|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
It is perfect, exactly what we needed. It's like the paper version but less clutter.
 ;
Received my manual within 24 hours. Very clear scan of the manual I needed. Thanks!
;
Very clear scan, I recommend it. Definitely a must have for any 3362 owner.
Alpine could have written a slightly more complete manual, though. It's already pretty huge, but the unit has so many functions, I feel some more explanation would have been better.
Yamaha's manual of their comparable YDSP-1 is a little better in my opinion.
;
Immediate response with excellent service - highly reccommended
;
Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
Whenthe control knobis turned ON, gas will flow intothe burner. The solid state igniter will click as long as the knob is in the Lite position. (Note: All burner igniters will spark regardlessof which burner is being operatedwhen a knob isturned to the Iite position.) A properly adjusted burner with clean ports will light within a few seconds. On natural gas, the flame will be blue with a deeper blue inner core. There should be no trace of yellow in theflame. A yellowflame indicatesan impropermixtureof air/gas. This wastes fuel, so havea servicemanadjust the mixtureif a yellow flame occurs. On LP gas, some yellow tipping is acceptable. This is normal and adjustment is not necessary. The infinite surface controls provide flexibility in heat setting selection. (See page 7,)
In case of prolonged powerfailure, youcan manuallylight the surfaceburner by holding a lightedmatchnearthe burnerportsand slowlyturningthe controlknobcounterclockwise (after depressing) to the LJte setting. CAI,ITION: When lightingthe surface burner, be sure all of the controlsare in the OFF position. Strike the matchfirst and hold it in position beforeturning the knobto the Lite position. Note: Becauseyour overhead hood fan is electricit will notwork during a power failure so smoke and condensationcan gather.
COUNTERCLO£;KWlSE
The Lo setting should produce a stable flame when turning the knob from Hi to Io. The flame should extend to the outer edge of the lip of theburner capon the Lo settingand must be stable on all ports on Lo setting. To adjust" Operate burner on Hi for about 5 minutes to preheat burner cap. Turn knob back to Lo; remove knob, and insert a small screwdriver into the center of the valve stem. Adjust flame size by turningadjustment screw in eitherdirection while holdingthe valve stem securely.
t TO,NCREASE _LAME _ _1 SLzE CLOCKW,SE.IIII A TO REDUCE FLAME SIZE
STEM
,
,
VALV W
Flame must be of sufficientsize to be stable on all burner ports. If flame adjustment is needed,adjust ONLY on the Lo setting. Never adjust flame size on a higher setting. Note: All gas adjustments should be done by a qualified servicer only. 6
|
|
|
> |
|
