PHILIPS CD6402B/79
Owner's Manual

9

Frequently asked questions
www.philips.com/support The is blinking. � Move closer to the base station � Check battery level � Register the handset to the base station The appears soon after the batteries are charged. � Replace the batteries with new ones (use only RECHARGEABLE batteries) Set-up Caller ID does not work properly. � Check with your local phone company that the CID service is subscribed to � Let the phone ring at least once before answering The Call Waiting call cannot be answered. � Check with your local phone company and select the correct recall duration The handset LCD displays nothing. � Try again by disconnecting and connecting the base station power supply and follow the procedure to register a handset (see Section 5.8.6) � Make sure the two supplied rechargeable batteries have been inserted properly into the battery compartment � Remove and place back the handset batteries � Make sure the supplied batteries are charged up The handset displays Unregistered. � Follow the procedures to register the handset to a base

In this chapter you will find the most frequently asked questions and answers about your phone. Connection The handset does not switch on! � Charge the battery: Put the handset on charger. After a few moments the phone will switch on. � Check the charger connections � Use only the SUPPLIED RECHARGEABLE BATTERIES. The phone does not work at all. � Make sure that the adaptor and the phone cord are connected properly � Check that the batteries are fully charged and installed properly � This phone does not work during power failure Communication is lost during a call! � Charge the battery � Move closer to the base station Poor audio quality � Move closer to the base station � Move the base station at least one metre away from any electrical appliances No dialling tone � Check the connections. Reset the phone: unplug and plug back in the mains. � Charge the batteries for at least 24 hours � Move closer to the base station � Use the line cable provided � Connect the line adaptor (when needed) to the line cord

34

Frequently asked questions