|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This is a very good quality print (scan) of the original SONY service manual. The original from Sony is on very thin paper. Nevertheless it is very clear and sharp and excellent readable. I'm very satisfied to have now this rare document. I've looking for it many years (infrequent). It contains very detailed circuit diagrams, exploded views, part lists, PCB view with good readable connection lines. Very recommended.
;
A complete manual with all the needed details of calibrations and service instructions about the radio receiver.
A big deal.
Many thanks !
;
Fast delivery and good quality copy. To be recommended
;
Excellent product, very clear print. Detailed circuit and assembly diagrams - this enabled me to repair my CD player with confidence. I highly recommend this site.
;
Fast access, 100% correct and complete service manual
11. TRAY MECHANISM ADJUSTMENTS
1. When mounting tray and tray case (when replacing tray case because of damage etc.) a) When the tray has been positioned improperly with a deviated clearance to the front panel window, re-move the tray lid, loosen screws A and adjust by moving the tray frame within the range of the holes play. 2.When the tray Is disengaged to the lower side 3.When replacing the sub-chassis (VAM1252) a) The height of the sub-chassis turn table is different one by one. Adjust each turn table height so that the magnet clamper does not touch the clamper metal strap as shown in the figure. Standard ( 1.5+0.3 / -0 mm) 4.Others a) For the loading wire winding, refer to the figure be-low. Wind from inside to outside (1 2 3).
Tray
A
1.5 ±
When the tray is pushed downward without the sub-chassis (VAM1252), it will be disengaged. So care will be necessary.
Tray lid Retainer
0.3 0
mm
Clamper metal strap
Tray
DISC
A Tray case
Wind form inside to outside 1
(Closing the tray without the sub-chassis also disengages the tray.) Mount the tray referring to the figures below.
Clamper metal Strap height adjustment screw
2
3
A Tray lid Glass
b) When the magnet clamper (094M) is replaced, bent the narrowest tab and remove the clamper. Bend the narrowest tab.
a) Bring down the lever and put the tray on the protrusion of lever.
For the tray tilt adjustment. refer to the figure below.
Tray
Lever
Tray case
a
Mechanism chassis
b
b) While holding the tray, bring down the opposite lever and put the tray on the protrusion of the lever. b) After replacing the sub-chassis, readjust so that the magnet clamper does not touch the clamper metal strap at right and left sides. (The clamper metal strap should not be touched to other straps.)
Protrusion
Bend the narrowest tab
a = b = 29.0 ± 0.2 a - b ±0.2
Front side
Adjust the tilt with screws A. b) The operating power of the tray is set to 250 - 350gr (Power OFF). Note : If both the levers are brought down at the same time, the tray cannot be raised. The levers should be brought down one by one. If the tray is forced to move to the original position, the two
250 ~ 350gr
Clamper arm adjustment screw
Clamper arm Clamper
pins injected into the tray case may be bent.
33
34
|
|
|
> |
|
