|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I PURHASED THIS PRODUCT BECAUSE I WAS HAVING PROBLEMS WITH MY CDR20 HARMAN KARDON RECORDER. WHICH I PURCHASED NEW 12 YEARS AGO. AFTER REVIEWING THE MANUAL, I WAS ABLE TO ADJUST THE TENSIONER IN THE SYSTEM. WORKS LIKE A CHAMP!.
SAVED ME AT LEAST 100.00 WHICH WAS WHAT A SERVICE REPAIR STATION WANTED. GREAT MANUAL EASY TO READ. SPECIALLY AFTER I PRINTED THE PAGES WHICH DEALT WITH MY RECORDER. THANKS A LOT!!!!!!!!
 ;
You can fully trust on this one!
All the schematics are very crear an in one piece per page
;
I have never bought a service manual which is as competely readable as this althogh it was a scanned pdf. Thank you for this succesful manual also cheaper than other sites.
;
Thanks for a very good and readable servicemanual. Just what I needed as a "dinosaur technician". I really recommmend this site and will come back.
Åsbjörn
;
The manual I purchased was just what I needed. I was glad to find a site where I can find so many manuals on a wide variety of products.
DISASSEMBLY INSTRUCTIONS
1. Using the unlock key that came with the unit or a similar tool, unlock the Mounting Box and remove toward the rear of the unit. 2. Remove the screw (A) located on the rear of the top cabinet and remove the Top Cabinet. 3. Remove two screws (B) located on the rear of the bottom cabinet then remove the Bottom Cabinet. 4. Remove two screws (C) (one located at the left side and one located at the right side of the Front Bracket) then remove the Hooks. 5. Remove the Front Panel and the Ring. 6. Remove two screws (D) from each side of the base then remove the Base. 7. Remove two screws (E) from the front bracket and remove two screws (F) from the rear cabinet. 8. Remove two screws (G) from the front deck bracket then remove the Front Deck Bracket. Remove two screws (H) from the rear deck bracket then remove the Deck and the Rear Deck Bracket. 9. Remove the screw (I) and three screws (J) from the Heat Sink then remove the Heat Sink and the K7377 Heat Sink. 10. Remove the screws (K) and remove the Antenna Clip. Remove the screw (L) and remove the Wire Clip. 11. Remove two screws (M) from the rear cabinet of the right side then remove the IC7805 Bracket. 12. Remove five screws (N) from the main board then remove the Main Board.
13.
Remove four screws (O) from each side of the rear cabinet then remove the Front Bracket and the Rear Cabinet.
3
|
|
|
> |
|
