|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Hard to find manual was ready the next day. Scans were very legible (including schematics). All the essential parts of the service manual were present (adjustment procedure, schematics, and parts list). It would have been nice if the rest of the manual was included (disassembly procedure, theory of operation, etc.).
 ;
The Service Manual for the Kenwood KR-V55R provided by owner-manuals.com was as described/advertised. The contents provided the necessary information to effect a diagnosis of the unit. The schematics above all else was instrumental in tracing the the signal flow from component to component.
;
This manual was the factory original. Excellent value and contained all the details I needed. Easy dowwnload provided the information when I needed it.
;
Impeccable, document très complet. Perfect, i get all i need. All schematic are correct. Thanks
;
The manual is of better quality compared to other. I found it less expensive and therefore it it is the best buy cost vs quality.
CD-BK260V/CD-BK2700V/CD-BK280V
(2) Tracking system check. Check the TE waveform at pin 18 on IC1.
If the waveform shown in Figure 47-1 appears and soon after NO DISC appears ? No "Initialization" is possible, but play is not possible ? No Yes The tracking servo is not activated. Check the peripheral circuits at pins 18 and 19 on IC1, pin 23 on IC2, and CNS1A/B.
Yes
A normal jump operation cannot be completed or the beginning of the track cannot be found. Check the around pin 23 on IC2.
"Initialization" is not possible.
Data cannot be read. Check the VCO-PLL system.
Stopped CH1=10 V DC 10:1
T
CH2=1 V DC 10:1
100 ms/div (100 ms/div) NORM:100 kS/s
TE
2
T 1
DRF
=Filter= Smoothing : ON BW : FULL
=Offset= CH1 : 0.0 V CH2 : 0.00 V CH3 : 0.00 V CH4 : 0.00 V
=Record Length= Main : 100 K Zoom : 2K
=Trigger= Mode : NORMAL Type : EDGE CH1 Delay : 2.924 ms Hold off : 0.2 µs
Figure 47-1 (3) Spin system check.
Press the OPEN/CLOSE switch without inserting a disc, and then try starting the play operation.
1. The turntable rotates a little ? (Waveform drawing 47-2) Yes No
The spin driver circuit is OK.
2. The turntable doesn't rotate.
Check around pin 25 on IC2, pins 15 and 16 on IC3, and CNS3A/B.
Stopped
CH1=200 mV DC 10:1
T
CH2=500 mV DC 10:1
1999/04/07 09:51:15 500 ms/div (500 ms/div) NORM:20 kS/s
T
FDO
2
1
SPDO
=Filter= Smoothing : ON BW : FULL
=Offset= CH1 : 0.000 V CH2 : 0.000 V CH3 : 0.00 V CH4 : 0.00 V
=Record Length= Main : 100 K Zoom : 2K
=Trigger= Mode : NORMAL Type : EDGE CH2 Delay : 2.924 ms Hold off : 0.2 µs
Figure 47-2
� 47 �
|
|
|
> |
|
Home
