|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Another excellent buy! A fully readable PDF archive. Good prints!!
;
It is wonderful done!!! a great job in scanning the manual. Superior quality in all the electric scheme. Very understandable and net!!! Thank you!
 ;
muy buen manual por lo completo de este algunos esquemas estan muy divididos lo que hace algo dificil el seguimiento.
;
very good manual, with detail and clarity in esquematic diagrams and waveforms .
;
Very quality copy of original service manual, which contains the circuit diagrams, PCB and lists of components, well as recommendation for calibration procedures of device, also everything else, that need for repair, tuning and use this oscilloscope.
All presented copies have high-resolution, so you can view all in detail.
This manual will very useful for simple owners and for repairers.
I recommend these manual, because myself is owner of Philips PM3216 and I need sometimes servicing these oscilloscope (principally calibrating).
Also, these document is an example of excellent design of technical documentation.
CD-BP1300W/BP1350W
NOTES ON SCHEMATIC DIAGRAM
� Resistor: To differentiate the units of resistors, such symbol as K and M are used: the symbol K means 1000 ohm and the symbol M means 1000 kohm and the resistor without any symbol is ohm-type resistor. Besides, the one with �Fusible� is a fuse type. � Capacitor: To indicate the unit of capacitor, a symbol P is used: this symbol P means micro-micro-farad and the unit of the capacitor without such a symbol is microfarad. As to electrolytic capacitor, the expression �capacitance/withstand voltage� is used. (CH), (TH), (RH), (UJ): Temperature compensation (ML): Mylar type (P.P.): Polypropylene type � Schematic diagram and Wiring Side of P.W.Board for this model are subject to change for improvement without prior notice.
REF. NO SW1 SW2 SW3 SW4 SW701 SW702 SW703 SW709 SW710 SW711 SW712 SW713 SW714 DESCRIPTION OPEN/CLOSE CLAMP DISC NUMBER PICKUP IN ON/STAND-BY CLOCK TIMER/SLEEP DISC SKIP OPEN/CLOSE EQUALIZER/X-BASS/DEMO VOLUME UP VOLUME DOWN CD POSITION ON�OFF ON�OFF ON�OFF ON�OFF ON�OFF ON�OFF ON�OFF ON�OFF ON�OFF ON�OFF ON�OFF ON�OFF ON�OFF SW802 SPAN SELECTOR
� The indicated voltage in each section is the one measured by Digital Multimeter between such a section and the chassis with no signal given. 1. In the tuner section, ( ) indicates AM < > indicates FM stereo 2. In the main section, a tape is being played back. 3. In the deck section, a tape is being played back. ( ) indicates the record state. 4. In the power section, a tape is being played back. 5. In the CD section, the CD is stopped. � Parts marked with � �( ) are important for maintaining the safety of the set. Be sure to replace these parts with specified ones for maintaining the safety and performance of the set.
REF. NO SW715 SW716 SW717 SW718 SW719 SW720 SW721 SW723 SW724 SW725 SW801 TAPE
DESCRIPTION
POSITION ON�OFF ON�OFF ON�OFF ON�OFF ON�OFF ON�OFF ON�OFF ON�OFF ON�OFF ON�OFF 110V/127V/220V/ 230-240V 50/9kHz-100/10kHz
TUNING /TIME DOWN MEMORY/SET REWIND FAST FORWARD PLAY/REPEAT STOP REC/PAUSE TUNING/TIME UP TUNER (BAND) VOLTAGE SELECTOR
FRONT VIEW
FRONT VIEW
FRONT VIEW
EC B (S) (G) (D) (1) (2) (3) 2SC1845 F KTA1266 GR KTA1268 GR KTA1271 Y KTA1273 Y KTC3203 Y KTC3194 Y KTC3199 GR KTC3200 GR KRC102 M KRC104 M KRC107 M
BC
E 4204SRT7
KTC2026
Figure 30 TYPES OF TRANSISTOR AND LED
� 30 �
|
|
|
> |
|
