|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I do not have very much to say.
The price is quite covenient, delivery was better as promised (about 12 ours, against the specified 24 hours if I remember well), and the quality of the PDF is more than acceptable.
The Service Manual of Sansui R30 itself is also satisfactory: good graphic for schematics and layouts, simple and well structured.
Giovanni Bianchi
 ;
Happy to find finally a schematic for this amplifier. The schematic is of good quality, the pcb layout is useless: all is black. Never the less, it is very easy to find the components on the board using the schematics.
 ;
Hard to find manual was ready the next day. Scans were very legible (including schematics). All the essential parts of the service manual were present (adjustment procedure, schematics, and parts list). It would have been nice if the rest of the manual was included (disassembly procedure, theory of operation, etc.).
 ;
The Service Manual for the Kenwood KR-V55R provided by owner-manuals.com was as described/advertised. The contents provided the necessary information to effect a diagnosis of the unit. The schematics above all else was instrumental in tracing the the signal flow from component to component.
 ;
This manual was the factory original. Excellent value and contained all the details I needed. Easy dowwnload provided the information when I needed it.
CD-C811W/821W
� Check the tracking system.
Check waveform of IC1 pin 7 (TE). The waveform shown in Fig. 44-1 appears, and no-disc state appears soon. Tracking servo is inoperative. Yes Check the periphery of IC 1 pin 8 to pin 15, and IC 5 to CNP2.
Yes
Play is possible in TEST mode.
Yes
The unit will be initialized in Normal mode,but it will not playback..
Yes
Normal jump is impeded, and the program top cannot be reached.
5ms 1.00 V IC1 7 TE
Yes
Check the periphery of IC 1 pin 14.
Data cannot be read. Yes
Check the VCO-PLL system.
4
5 ms 5.0 V IC1 54 DRF
3
Figure 44-1 � Checking the spin system.
Play operation is performed without disc.
The turntable rotates a little. No The turntable fails to rotate or rotates at high speed.
Yes
The spin driver circuit is normal.
Yes
Check the periphery of IC1 pins 23 to 27, pin 39, and pin 40, IC2 pin 12 and pin 13, IC3 to CNP3.
� Checking the VCO-PLL system
Play operation is performed when disc exits. Yes Although HF waveform is normal, TOC data cannot be read. Yes Check PDO waveform (Fig. 44-2). Abnormal Check the IC1 pins 43 and 44, IC2 pins 3, 5, 7, 10, and 11.
Stop --> Play As VCO frequency is locked at 4.32 MHz, voltage of PDO rises and stabilizes. 2
0.5s 1.00 V IC2 3 PDO 0.5s 1.00 V IC1 16 FD
3
� Although HF waveform is normal and the time indication is normal, no sound is emitted.
Check IC2 pin 48 (EFLG). Yes Check IC2 pins 37, 40. Abnomal Check IC401 and POWER AMP. IC601. No
Figure 44-2
Usually, the number of pulses of flawless disc is 100 pulses/sec or less.
� 44 �
|
|
 |
> |
|