|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very good manual for Technics SL 303. Manuale molto utile.
;
About one hour after checkout, the manual was available for download. Clear reading and detailed. Thanks
;
Excellent transaction - clean document received - Thanks a lot
;
Manual is in German but complete. I needed this one to fix a long lasting problem with the internal PSU of the camera. Most of the capacitors begin to leak after a few years wich results in the inability to power on the camera. When you try to turn it on the power led flickers and the unit directly turns off. Thanks to this manual I was able to locate all bad cap's and to dis- and reassemble the camera without any problems.
 ;
We received the manual in a timely manner and it was exactly what we were expecting.
CD-CH1500H/CD-CH1500W
Speaker System
CP-RW5500H/CP-RW5500W
1. Woofer 2. Tweeter 3. Subwoofer 4. Subwoofer Terminals 5. Main Speaker Terminals 6. Bass Reflex Duct
1
2
4 5
3 6
OPERATION MANUAL
Setting the Clock
5
Turn the jog dial to adjust the hour and within 2 minutes, press the ENTER button.
When the 12-hour display is selected, "AM" will change automatically to "PM".
6
Turn the jog dial to adjust the minutes and within 2 minutes, press the ENTER button.
In this example, the clock is set for the 24-hour (0:00) display.
The hour will not advance even if minutes advance from "59" to "00". The clock starts from "0" second. (Seconds are not displayed.) The time display will disappear after a few seconds. To confirm the time display: [When the unit is in the stand-by mode] Press the DISPLAY button on the remote control. The time display will appear for about 3 seconds. [When the power is on] Press the MENU button. The time display will appear for about 10 seconds. Note: "CLOCK" will appear or time will flash at the push of the DISPLAY button when the AC power supply is restored after a power failure or unplugging the unit. Reset the clock as follows. To reset the clock: [When time is flashing] 1 Press the ON/STAND-BY button. 2 Press the MENU button. 3 Press the ENTER button. 4 Perform "Setting the Clock" from step 5. [When "CLOCK" appears] Perform "Setting the Clock" from the beginning. To change the 24-hour or 12-hour display: 1 Clear all the programmed contents. [Refer to "Clearing all the memory (reset)".] 2 Perform "Setting the Clock" from the beginning.
1 2 3
Press the ON/STAND-BY button to turn the power on. Press the MENU button. Turn the jog dial to select "CLOCK" and within 10 seconds, press the ENTER button.
4
Turn the jog dial to select the 24-hour or 12-hour display and within 2 minutes, press the ENTER button.
"0:00" "AM 12:00" "AM 0:00"
The 24-hour display will appear. (0:00 - 23:59) The 12-hour display will appear. (AM 12:00 - PM 11:59) The 12-hour display will appear. (AM 0:00 - PM 11:59)
Note that this can only be set when the unit is first installed or it has been reset. [Refer to "Clearing all the memory (reset)".]
�8�
|
|
|
> |
|
