|
Who's Online
There currently are 5851 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Very complete and well reading drawings. Documentation is essential for successful repairs.Good documentation, with all that is necessary. This manual was what I was waiting with all the information necessary for the repairing I need it for. You must buy it if you want to do repairs or simply understand how it works.
;
Excellent service manual includes everything is need to repair this radio-caseete, how to disassemble, wiring diagram, all , waiting time until the download was only a few hours. I'm going to buy service manuals from here, are cheap and very good.Thank you.
;
Good service manual,i saved from scrapping this deck,is now fully functional.Thanks.
;
Found this to be the manual included with the original packinging, was helpfull but did not give any detailed repair instructions.
;
Complete service manual, was very helpful in repairing this tapedeck.Thanks.
CD-DVD500H
TROUBLESHOOTING
The disc does not rotate. Is the disc chucked at the specified location ? Yes No Repair the changer mechanism. No Check the changer mechanism. Yes Check the connection between pins 3 and 7 of IC705 and M3. Yes Replace IC705. Does the pickup move in the direction of inner periphery ? Yes After moving in the direction of inner periphery, does the pickup move in the direction of outer periphery ? Yes Is 8 V being applied to the pins 8 of IC3801 ? Yes Replace the IC3801. No Check the cable connecting to the CS3301. (Check the CS3301 and line of pins 13 and 14 of IC3801.) Check the cable connecting to the CS3301.
No
No
Check the M_8 V line.
The [No Disc] indication. (In case of focus error) When removing disc and applying load to spin No motor (by stopping with hand, etc.), objective lends moves up and down? (Checking item to symptom) Note) If load is not applied to spin, lens does not move and becomes NO DISC immediately. Yes Is FE signal output to the pin 21 of IC3301 when the disc is set ? Yes Is FE signal inputted into the pin 150 of IC3701. Yes Check or replace IC3701. Check the line between the IC3301 and IC3701. No No See FLOW CHART <The [No Disc] indication. (In case focus servo does not function.)>
Replace IC3301. Yes Is there input signal on the pins(50,55) and (49,54) of IC3301? No Check the connection of optical pickup cable. If it is normal, replace the optical pickup. In case of CD. For DVD, 58, 59, 63, and 64
� 68 �
|
|
|
> |
|