|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The manual was properly scanned and perfectly readable. The only small problem is that I couldn't use my dear Ctrl + F to find a word I needed.
;
Nothing wrong with the manual or the delivery - came to me the same day I ordered it. But afterwards I realized that I ordered the wrong manual. Probably better with the Quick start - version. So maybe it would be better if we could see a list with inhold for each manual before ordering?
 ;
Bought T4850 High End Tuner a few years ago, but i didn't know where all the buttons were used for. So i purchased the owners manual. Perfect! Just what i needed.
;
Bought the used Philips car-radio. No manual! Found on this site a copy of the orginal English manual. I am very happy with it. Now I know how to setup and use my "new" car-radio.
Recommended site for everybody looking for a manual for (older) products!
;
Great deal, you are the only one on earth who could deliver this old manual. Thx so much and have nice chrismas
P.17
Loop Playback (*)
7 Defining a loop 1. Press the PLAY/PAUSE button (6) to begin playback. 2. During replay, press the LOOP IN/REALTIME CUE button at the loop in point.
¶ Note that this operation need not be performed if a prerecorded Cue point is to be used as the start of the loop.
3. Turn the Jog dial in the direction and at the speed you wish to playback the disc.
¶ The CD is played back according to the speed and direction of Jog dial movement. ¶ The CD spins up or down to return to normal playback mode. (The slowdown or increase in speed until the CD returns to normal playback (response characteristics) can be set separately.)
4. Take your hand off the surface of the Jog dial.
3. During playback, press the LOOP OUT button at the point from which you wish to end the loop.
¶ Loop playback will begin, with playback looping from the loop start point to the loop end point.
7 Setting the time it takes for playback to slow down and stop when the Jog dial surface is pressed. Turn the VINYL SPEED ADJUST TOUCH/BRAKE knob.
¶ This knob allows you to adjust the slowdown in speed (response characteristics) until CD playback stops.
7 Stopping loop playback During loop playback, press the RELOOP/EXIT button.
¶ Once this has been done, playback will continue in sequence from the loop end point without returning to the loop start point.
7 After you have taken your hand off the surface of the Jog dial you can set the time it takes for the speed to return to the original condition of playback. Turn the VINYL SPEED ADJUST RELEASE/START knob.
¶ This allows you to adjust the slowdown or increase in speed until the CD returns to normal playback (response characteristics).
7 Changing the loop in point 1. Press the LOOP IN/REALTIME CUE (IN ADJUST) button during playback.
¶ The time of the in point is shown in the display, the LOOP IN/REALTIME CUE button starts to flash rapidly and the LOOP OUT button goes off.
How to Spin (*)
During playback in the VINYL mode either press the surface of the Jog dial or press the PLAY/PAUSE button (6) to cause a pause, then quickly turn the Jog dial, even when released playback will occur according to the speed and direction of the dial.
2. Press the SEARCH button (1, ¡) or turn the Jog dial.
¶ In a 1 frame unit you can move the loop in point up to ±30 frames. ¶ Press the LOOP IN/REALTIME CUE button or wait 30 seconds to leave editing mode and return to loop play.
14
<DRB1297> En
|
|
|
> |
|
