PIONEER CDJ-800/KUCXJ
Owner's Manual

ADVANCED OPERATIONS
7 To create an automatic loop based on the track�s BPM (AUTO BEAT LOOP)
During playback or pause, press one of the AUTO BEAT LOOP buttons (1, 2, 4 or 8). ÷ The pressed button will flash, the loop out point will be automatically set based on the track�s BPM, and loop play will begin. ÷ When AUTO BEAT LOOP 1 button is pressed, the loop-out point is set one beat after the instant the button is pressed. ÷ When AUTO BEAT LOOP 2 button is pressed, the loop-out point is set two beats after the instant the button is pressed. ÷ When AUTO BEAT LOOP 4 button is pressed, the loop-out point is set four beats after the instant the button is pressed. ÷ When AUTO BEAT LOOP 8 button is pressed, the loop-out point is set eight beats after the instant the button is pressed. ÷ This function operates only from pause mode with the JOG MODE set to VINYL if reverse play has been set (when REV button is lighted). ÷ After an AUTO BEAT LOOP has been set, if one of the AUTO BEAT LOOP buttons (1, 2, 4, or 8) is pressed again, a new loop play will begin using the previously set loop-in point, with a new loop out point automatically set based on the track�s BPM.

Fader Start Playback (*)
The supplied control cord may be used to connect the CONTROL terminal on the CDJ-800 to a CONTROL terminal on a DJM-300, DJM-500, DJM-600 or DJM-3000 mixer, thus making it possible to exit from cueing standby mode and to start playback immediately by raising the DJ mixer channel fader. The cross fader may also be used to perform fading starts on the player as well. The fader may also be returned to its original position to return the player to the cueing point (i.e., to perform back cueing). (See page. 7 for instructions on how to connect the player.)

Relay Play Using Two Players (*)
If you connect the CONTROL terminals of this player with another CDJ series CD player using the supplied control cord then you will be able to relay play.