|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very good reproduction (copy) of original manual. Didn't have a parts list, but schematic was completely labeled with parts. Complete instructions on how to adjust mechanical functions of the 8-track deck. Well worth having and at a very reasonable cost.
;
It's a full manual. All the parts are in there. I haven't found the problem yett, but I am working on it; hope I can rebuild the part myself. To make it more secure and unbreakable this time. Because the part has failed several times before and costs a lot to let it be repaired.
Thanks so much for this rich illustrated and parted manual.
;
I downloaded the document. The manual was complete, well scanned and everything was legible. I could zoom in see what I needed to know. There's not much more that you can ask.
;
It was complete service manual with all needed service informations. Thanks.
 ;
El manual esta muy detallado, los numeros de partes y los esquemas de despiece son correctísimos y muy claros, tanto para los técnicos experimentados como para los novatos.
CD-K7000W/C7000W,CP-C7000
How to remove the belt (TAPE 1) (See Fig. 13-1)
1. Remove the main belt (D1) x 1 pc., from the motor side. 2. Remove the FF/REW belt (D2) x 1 pc.
How to remove the belt (TAPE 2) (See Fig. 13-1)
1. Remove the main belt (E1) x 1 pc., from the motor side. 2. Remove the FF/REW belt (E2) x 1 pc.
How to remove the motor (See Fig. 13-2)
1. Remove the screws (F1) x 2 pcs., to remove the motor.
Motor
Motor TAPE2 FF/REW Belt (E2)x1 Motor TAPE2 Main Belt (E1)x1 TAPE1 Main Belt (D1)x1
(F1) x2
�2.6x5mm
TAPE1 Main Belt FF/REW Belt (D2)x1
Figure 13-1
Figure 13-2
CD MECHANISM SECTION
Perform steps 1, 2, 3, 13 and 16 of the disassembly method to remove the CD mechanism.
Loading Motor
How to remove the loading motor (See Fig. 13-3)
1. Bend the hooks (A1) x 5 pcs., to remove the loading motor.
(A1)x2
(A1)x1 (A1)x2 CD Base
Figure 13-3
How to remove the pickup (See Fig. 13-4)
1. Remove the stop washer (B1) x 1 pc., to remove the gear (B2). 2. Remove the screws (B3) x 2 pcs., to remove the shaft (B4). 3. Remove the pickup. Note After removing the connector for the optical pickup from the connector wrap the conductive aluminium foil around the front end of connector so as to protect the optical pickup from electrostatic damage.
Stop Washer (B3) x2 ø2.6 x6mm (B1) x1
Pickup Shaft (B4) x1 Gear (B2) x1
Figure 13-4 � 13 �
CD Mechanism
|
|
|
> |
|
