|
There are currently no product reviews.
 ;
Fint forløb med levering af manualen. Kvaliteten af skanningen betegnes som middel
 ;
I found the manual to be clear concise and complete. It was of immense assistance when removing the unit as the unit was over 22 years old and the wiring diagram was unobtainable from the manufacturer. The exploded drawings were clear as were the instructions and labels.
;
I will highly recommend this seller. They are honest, accurate, fast and responsible.
;
This manual was very good & was very helpful with repairs.
Always great & fast service from Owner's manual.
;
Very pleased with the quality of the scan. No complaints whatsoever.
HOW TO OPEN THE DISC TRAY WHEN POWER SWITCH TURNS OFF
Insert a tapeing driver into the aperture of the unit bottom, and turn in the direction of arrow (to OUT direction.) * To close the disc tray, turn the driver in the reverse direction(to IN direction).
NI
OU T
Tray
NOTE FOR MAIN GEAR INSTALLATION
5 Rotate the MAIN GEAR until the portion that has no gears, of the MAIN GEAR is aligned with the shaft of the GEAR (REV). Then insert the GEAR (REV). 6 Stopper washer (5)
Projected portion
3 Install the MAIN GEAR while aligning the protrusion of the MAIN GEAR to the cut-off of the ENCODER. 2 Set the cut-out of the ENCODER to the right when viewed from the front view. A
1 Rotate the GEAR (U/D) to the arrow A direction.
SHAFT
B
Front view
B 4 Open the SET LEVER and LOCK LEVER in the direction of the arrow B, and push in the MAIN GEAR.
�4�
|
