|
There are currently no product reviews.
 ;
Very nice and real Service Manual, I didn't thought it actually exist in the real world at all.
 ;
VERY NICE FOR COURTESY AND PRECISION!.
tHE SITE IS VERY IMPORTANT FOR ALL DEVICES
vERY GOOD
;
+++ Is is fine, that was what i looking for. Thanks! +++
;
A very good complete archive, i am very satisfied for document.
;
The Service Manual received was helpful. The electronic information is exactly what I needed.
HOW TO OPEN THE DISC TRAY WHEN POWER SWITCH TURNS OFF
Insert a tapeing driver into the aperture of the unit bottom, and turn in the direction of arrow (to OUT direction.) * To close the disc tray, turn the driver in the reverse direction(to IN direction).
NI
OU T
Tray
NOTE FOR MAIN GEAR INSTALLATION
5 Rotate the MAIN GEAR until the portion that has no gears, of the MAIN GEAR is aligned with the shaft of the GEAR (REV). Then insert the GEAR (REV). 6 Stopper washer (5)
Projected portion
3 Install the MAIN GEAR while aligning the protrusion of the MAIN GEAR to the cut-off of the ENCODER. 2 Set the cut-out of the ENCODER to the right when viewed from the front view. A
1 Rotate the GEAR (U/D) to the arrow A direction.
SHAFT
B
Front view
B 4 Open the SET LEVER and LOCK LEVER in the direction of the arrow B, and push in the MAIN GEAR.
�4�
|
