|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The manual is of better quality compared to other. I found it less expensive and therefore it it is the best buy cost vs quality.
 ;
I bought the service-manual of the sony ICB-1020(an old transmitter-receiver) at "www.Owners-Manual.com", I found the service-manual for a fairly cheap price(in comparison with other sellers). I filled in some questions, payed the order with Ideal, and within 24 hours I had my service manual. I was very happy:In no time I had my service-manual and everything, but literally everything was noted down in the manual; the electronic scheme, the parts list, etcetera.
A very practical, reference-document.
;
This comprehesive service maual was greatly appreciated, as was the digital download.
;
Good en helpfull black and white scanned Srfvice manual of the Philps D8444. Quick service and delivery
;
Scan was really good quality, easy to read, download easy
SENSOR ALIGNMENT Perform this adjustment after the �holder (disc A) adjustment�. If the disc table swings to the left and right just before the disc is chucked, perform the following adjustment.
CAUTION: The LED may not light up in steps (3) and (4) for some microprocessor versions, and consequently adjustments will not be possible. In this case, fix the bracket (sensor) at the mechanical center. As fine adjustments need to be performed in �Disc Sensor Adjustment� in Electrical Adjustments, sensor alignment need not be performed here.
Cam Lever (stopper) assembly
Cam
(1) Rotate the cam and adjust to the position shown in the figure.
Bracket (sensor)
Table assembly
(2) Check that the lever (stopper) assembly secures the disc table as shown in the figure.
Disc table
Swing
Lever (stopper) assembly
(4) Moving the disc table right and left with a hand after the screw is fixed, the table will move by the play of a disc table. If the LEDs light up alternately, the adjustment will be performed correctly.
Tapering screwdriver
Luminus board
PLAY button Bracket (sensor)
PAUSE button
Fixed screw
(3) Loosen the fixed screw by 60° to 90°, and use a tapering screwdriver to adjust the screw as shown in the figure. Move the bracket (sensor) with the tapering screwdriver little by little, and fix the fixed screw at where the play button's LED (green) is switched to the pause button's LED (orange) (or its reverse).
� 16 �
|
|
|
> |
|
