Manual correct, and complete. Downloads cleanly. Format of manual was presumably difficult to PDF to A4, but works reasonably well.
Text excerpt from page 24 (click to view)
Synchronous recording (component system operation)
4 Adjust the recording level.
(1) Press the EDIT/NO button and turn the MULTI JOG dial until "Rec Level?" appears.
MULTI JOG
EDIT / NO
(4) After adjusting the recording level, press the MULTI JOG dial.
Pressing the YES button provides the same operation.
MULTI JOG
PUSH TO ENTER
PUSH TO ENTER
5 Stop the CD player.
(2) Press the MULTI JOG dial.
Pressing the YES button provides the same operation. Press the EDIT/NO button if you cancel the adjustment operation.
6 Press the s button on the CD player.
The CD player starts playing and recording starts at the CDR-201A.
(3) Turn the MULTI JOG dial to adjust the recording level as desired.
The current level is displayed, ranging from -� to +18 dB.
MULTI JOG
When the CD finishes
The CDR-201A automatically returns to the recording standby state.
To stop the CD synchronous recording
Stop play at the CD player. The CDR-201A enters the recording standby state.
PUSH TO ENTER
Adjust so that when the recording level is at its highest, it does not reach "OVER" in the front display. If OVER is reached, the sound becomes distorted.
Adjust the level so that "OVER" will not light.
Note: During analog recording, set the input dial on the amplifier to the CD position and be sure not to change this setting during recording. If this setting is changed, the CDR-201A will automatically enter the recording standby state.
L
40 20 10 4 2 0 OVER
R
For digital recording Even if you change the recording level, the monitor sound level from the DIGITAL OUT terminal will not change.
