|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I found the manual to be clear concise and complete. It was of immense assistance when removing the unit as the unit was over 22 years old and the wiring diagram was unobtainable from the manufacturer. The exploded drawings were clear as were the instructions and labels.
;
I will highly recommend this seller. They are honest, accurate, fast and responsible.
;
This manual was very good & was very helpful with repairs.
Always great & fast service from Owner's manual.
;
Very pleased with the quality of the scan. No complaints whatsoever.
 ;
I liked the product. I would use their sevices again.
SECTION 6 ELECTRICAL ADJUSTMENTS
Note: 1. Perform adjustments as given. 2. Power supply voltage: DC14.4 V (more than 3A).
� TRACKING OFFSET CHECK
[RF BOARD] � Conductor Side �
� FOCUS BIAS CHECK
CNJ12
[RF BOARD] � Conductor Side �
oscilloscope + � BP11 (TE)
+ �
oscilloscope CNJ12 TP (RF)
IC51
TP (VC) IC11
TP (VC) IC11
Procedure: 1. Connect the oscilloscope to BP11 (TE) and TP (VC) on the RF board. 2. Put the set into play mode by loading the disc. 3. Press the = AMS + button, and check the traverse waveform*.
IC51
Procedure: 1. Connect the oscilloscope to TP (RF) and TP (VC) on the RF board. 2. Put the set into play mode by loading the disc. 3. Confirm that oscilloscope waveform is clear and check RF signal level is correct or not.
Note: Clear RF signal waveform means that the shape ��� can be clearly distinguished at the center of the waveform.
4. Confirm that the oscilloscope waveform is symmetrical on the top and bottom in relation to 0 V dc, and check this level.
* Traverse waveform: This is the tracking error wave form appears when crossing the track.
Traverse waveform
VOLT/DIV : 500 mV TIME/DIV : 2 ms Center : 0 V
RF signal waveform VOLT/DIV: 200 mV TIME/DIV: 500 ns level: 1.4 ± 0.3 Vp-p
A 0V B A=B traverse waveform (100 track jump waveform)
� 16 �
|
|
|
> |
|
