|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Exactly what I needed to be able to bring the amp back to life... will come back to this site the next time I need schematics.
;
Information was accurate and very helpful.
However the continuity made it a little difficult to follow from one page to the next.
 ;
Very very good as usual very trustable site. Perfect!!!!!!
;
The Service Manual received was helpful. Good copy of original document.. I recomend all of my friends about this technical page.
;
Perfect, complete manual, exactly what I needed. Recommended to everyone.
4)
To fix C-In line connector to ECR. Connect the C-In line cable and C-In line connector as shown below: [Connector on the end of C-In line]
Terminal cap
Red
Red
C-In line connector
C-In line cable
Black Wrap bent shield wire with Copper tape. Shield wire Terminater (100 ohms)
Black
Notes: 1. Use crimp tool for connecting terminal caps. 2. If crimp tool is not available, connect the wires with solder instead of terminal cap. After the soldering, insulate the wires with vinyl tape.
[Connector between ECRs]
Terminal cap Red Red C-In line connector
C-In line cable Black Wrap bent shield wire with Copper tape. Shield wire Black
Notes: 1. Use crimp tool for connecting terminal caps. 2. If crimp tool is not available, connect the wires with solder instead of terminal cap. After the soldering, insulate the wires with vinyl tape.
�4�
|
|
|
> |
|
