|
There are currently no product reviews.
 ;
The service manual is scanned, but high quality, high resolution. The smallest texts on schematics diagram is readable. Super! Thank you!
;
I am satisfied with the service. And if need another manual, i will definitely buy from this site. Keep up the good work.
;
have download a number of manuals todate , most are excellant, one or two sometimes a little difficult to read but a least avaialable, great site .
Brad.
;
Excellent had everything I wanted, very happy with purchase
 ;
This service is relatively cheap, document is fast available, schematic is readable.
Thanks.
3. Press the Start key to feed paper through the copier to determine if an adequate length of loop is formed before the Fusing Rollers.
1154D215AA
1154D212AA
1154D213AA
Retarded
Correct
Advanced
The loop length is too long causing the paper to have too much slack.
A good length of loop is No loop is formed causing the formed as the paper moves paper to be taut. into the Fusing Rollers. 4. If the timing is advanced or retarded, change the setting of Fuser Speed. Adjustments Retarded: Increase the setting. Advanced: Decrease the setting. 5. Check the length of loop again and repeat the above steps until a good length of loop is obtained. 6. Using the same procedure, adjust for �Heavy Stock 2 and OHP Film�. 7. After the adjustments have been made, touch �Ex.�.
1154D266CA
D-118
|
