|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
as always, rapid and efficient, very good and clear prints
details clearly visible keep going this way!!!!!!
;
I expect a wonderful result as alaways!!!!!!
Usually is much faster....
;
Wow very wonderful and clear!!!! I will always trust them
;
Providing the manual works fine, quickly and without any problems for an acceptable price. After printing the service manual it took me only a short time to repair my carradio from Clarion. Thank You! Greetings from Heiko
;
I was searching a way to modify the original phono-in entry (for connection of vynil disc player, with RIAA equalization) to a line-in entry (for connection of modern analog entries, eg. ipod, mp3player).
This service manual gave me the correct hints.
It contains very useful infos for repairing and modifing the hi-fi, such as disassembling instructions, block diagrams, schematic diagrams, PCB prints, replacement parts list.
Very good!
SECTION 2 GENERAL
Basic Operations
This section is extracted from instruction manual.
Playing a CD
Use these buttons for additional operations
1,2
3
POWER
^
6PUSH OPEN/CLOSE
Basic Operations
p VOLUME PRESET TIME SET
For hookup instructions, see pages 26 � 28.
1
Push 6 PUSH OPEN/CLOSE down to open the CD compartment and place the CD on the CD compartment.
Tip Next time you want to listen to a CD, just press ^. The player turns on automatically and starts playing the CD.
To adjust the volume stop playback pause playback
Do this Turn VOLUME (Press VOL +, � on the remote). Press p. Press ^ ( P on the remote). Press the button again to resume play after pause. Turn PRESET�TIME SET clockwise (Press + on the remote). Turn PRESET�TIME SET counterclockwise (Press =on the remote). Press 6 PUSH OPEN/ CLOSE. Press POWER.
go to the next track With the label side up
2
Close the lid of the CD compartment.
go back to the previous track
remove the CD turn on/off the player
3
Press ^. The player turns on (direct power-on) and plays all the tracks once.
Display
Track number Playing time
4
Basic Operations
Basic Operations
5
Listening to the radio
Use these buttons for additional operations
1
2
POWER
MODE
VOLUME
For hookup instructions, see pages 26 � 28.
1
Press RADIO BAND until the band you want appears in the display (direct power-on). Each time you press the button, the indication changes as follows: "FM1" n "FM2" n "AM". Hold down TUNE + or � until the frequency digits begin to change in the display. The player automatically scans the radio frequencies and stops when it finds a clear station. If you cannot tune in to a station, press the button repeatedly to change the frequency step by step.
Display
Tips � The "FM1" and "FM2" bands have the same functions. You can store the stations you want separately in "FM1" and "FM2". � If the FM broadcast is noisy, press MODE until �Mono� appears in the display and radio will play in monaural. � Next time you want to listen to the radio, just press RADIO BAND. The player turns on automatically and starts playing the previous station.
To adjust the volume turn on/off the radio
Do this Turn VOLUME (Press VOL +, � on the remote). Press POWER.
To improve broadcast reception Reorient the antenna for FM. Reorient the player itself for AM.
2
Indicates an FM stereo broadcast
for FM
for AM
6
Basic Operations
Basic Operations
7
�4�
|
|
|
> |
|
