|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very helpfull information and I highly recommend this source for needed information about your products.
 ;
More than pleased with my prurchase, very good product for the price.
;
This is a good quality scan of the service manual which includes an assembly diagram, block diagram, schematic, and parts list. Exactly what is needed to repair my KR-V55R receiver.
;
Excellent concise manual. All needed information was included. Typeface and diagrams were clear. Very fair price considering what others are charging. Many thanks
;
Response is a little slow- I had to wait 12 hours to receive download link but it says that it may take up to 24hrs.
Manual is old and was not produced in PDF- scanned copy is exellent.
Overall- value for money- I recommend
4-2. TUNER SECTION
� FM Section Setting: BAND switch: FM
FM RF signal generator
0 dB = 1 µV
FM FREQUENCY COVERAGE ADJUSTMENT Adjust for a maximum reading on level meter. L2 86.5 MHz (87.35 MHz) CT2 109.5 MHz (107.8 MHz)
telescopic antenna input 0.01 µF set
22.5 kHz frequency deviation by 400 Hz signal output level : as low as possible
FM TRACKING ADJUSTMENT Adjust for a maximum reading on level meter. L1 86.5 MHz (87.35 MHz) CT1 109.5 MHz (107.8 MHz)
FM IF ADJUSTMENT T1
� MW Section Setting: BAND switch: MW
AM RF signal generator Put the lead-wire antenna close to the set.
10.7 MHz MW FREQUENCY COVERAGE ADJUSTMENT Adjust for a maximum reading on level meter. L8 520 kHz (516 kHz) CT4 1,680 kHz (1,640 kHz)
MW TRACKING ADJUSTMENT
30% amplitude modulation by 400 Hz signal output level : as low as possible
Adjust for a maximum reading on level meter. L3 620 kHz CT3 1,400 kHz AM IF ADJUSTMENT Adjust for a maximum reading on level meter. T2 455 kHz
telescopic antenna input set
� SW Section Setting: BAND switch: SW1 or SW2 FINE TUNE control: mechanical mid
AM RF signal generator
SW1 FREQUENCY COVERAGE ADJUSTMENT Adjust for a maximum reading on level meter. L6 2.2 MHz CT6 7.3 MHz
11 PF
30% amplitude modulation by 400 Hz signal output level : as low as possible level meter (range: 0.5 � 5 V ac) 32 � set phones jack
SW1 TRACKING ADJUSTMENT Adjust for a maximum reading on level meter. L5 2.25 MHz SW2 FREQUENCY COVERAGE ADJUSTMENT Adjust for a maximum reading on level meter. L4 CT8 22.5 MHz 6.8 MHz
� Repeat the procedures in each adjustment several times, and the frequency coverage and tracking adjustments should be finally done by the trimmer capacitors. � Remove telescopic antenna in FM section adjustments.
SW2 TRACKING ADJUSTMENT Adjust for a maximum reading on level meter. L7 7 MHz ( ) : Saudi Arabia model
Adjustment Location: See page 10.
�9�
|
|
|
> |
|
