perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
Super nice! Good to have a manual in digital format.
Text excerpt from page 5 (click to view)
SETUP
Lamp
You may need to install the lamps prior to the initial operation of the fixture. Five JCD 200W halogen lamps are included. Warning! When replacing the lamp, please wait 15 minutes after powering down to allow the unit to cool down! Always disconnect from main power prior to lamp replacement. Do not touch the envelope (glass area) of the bulb with bare hands. If this happens, clean the lamp with alcohol and wipe it with a lint free cloth before installation.
L AM P I N ST ALL AT I O N
1) Remove the (S1) screws located surrounding the midline of the spheres as shown in the image. Pull the top cover out exposing the lamp and socket. (not shown) If replacing the lamp, remove old lamp first. Using a cloth or napkin hold the bulb and pull out of the lamp socket located inside the reflector. 5) 6) Replace with a new lamp. Replace top cover, align the screw holes and fasten the screws. S1
Top Cover
WARNING!
EXTREMELY HOT!
Allow time to cool before handling
2) 3) 4)
Additional screw on the back side not shown
Mounting
O RI E NT AT IO N
This fixture may be mounted in any position provided there is adequate room for ventilation.
RIG G ING
It is important never to obstruct the fan or vents pathway. Mount the fixture using, a suitable �C� or �O� type clamp. Adjust the angle of the fixture by loosening both knobs and tilting the fixture. After finding the desired position, retighten both knobs. Hanging Clamp � � � When selecting installation location, take into consideration lamp replacement access and routine maintenance. Safety cables should always be used. Never mount in places where the fixture will be exposed to rain, high humidity, extreme temperature changes or restricted ventilation.
