This GRUNDIG UV5A Owner Manual is not only an instruction manual but a total functional circuit description of the Multimeter and includes circuit diagram at the end pages. It is very helpful for repairing and calibrating the instrument. It is written in two languages English and German for international support. It was very easy to repair my unit with this document. Regards, Regis Pauly, Electrical Engineer.
The owner's manual was evetything I thought it would be. I was able to print it out using both sides of the paper in quick order, saving me a search online for a used one.
Fantastic quality and impressive delivery time. Based on this manual, I recommend this service without hesitation! Five Stars for certain.
Text excerpt from page 13 (click to view)
3.
Fixing the first wall bracket No 2 Draw a horizontal line through the vertical at 15mm from the ceiling as illustrated, or from a horizontal line drawn between the top of two adjoining wall cabinets. Place the top edge of the bracket against the line, aligning the centre of the bracket with the vertical line. If, the alignment is correct mark the centres for the keyhole fixing screws (not supplied) as illustrated in Fig. 3. Fixing the second wall bracket No 2 Draw a horizontal line through the vertical at X. X is determined by the height of the upper chimney. Place the bottom edge of the bracket against the line, aligning the centre of the bracket with the vertical line. If, the alignment is correct mark the centres for the keyhole fixing screws (not supplied) as illustrated in Fig. 4. Splashback (Optional) When the splashback is to be fitted, the distance between the cooker hood and the cooking appliance will be determined by the height of the splashback B, as illustrated in Fig. 4. Position the splashback on the worktop, ensuring the worktop is level first, as illustrated in Fig. 4; then holding the splashback against the wall mark the position of the holes for the fixing screws. The splashback must be fitted before installing the cooker hood. If the splashback is to be fitted in conjunction with a slot-in cooker, or free standing appliance then it will be necessary to fix the splashback to the wall using both the top and bottom wall fixing screw holes. Drill the holes for the fixing screws using an 8mm masonry drill and fix the wall brackets. Note: If the hood is to be installed onto a hollow construction or plaster or partition board wall then special fixing screws will be required (not supplied).
