Very satisfied! I was searching for several days, but nope; till I discovered your webside and there it was at a very reasonable price. Keep up the good work!
Paul
Flanders
I purchased the unit from a private party and the original owners manual was not available. Having the ability to download it was extremely helpful and clarified operating the equipment immensely. This is a complicated unit and without the manual I would not have been able to maximize it's potential. Thank you.
Text excerpt from page 15 (click to view)
Installation - Fig. 8
� Drill the base of the wall unit to allow for passage of the hood body. Fig. 7. � Drill the top of the wall unit to allow for passage of the exhaust pipe and the electrical cable. Fig. 7. � Remove the grease filter (1). � Remove the grease filter support frame, by pressing the two spring clamps located at the sides of the frame (2). � Through the top of the wall unit, insert a pipe with a diameter of 120mm at the connection ring (3). � Fit the connection ring on the hood exhaust outlet (4) and fasten it to the exhaust pipe. � Insert the body of the hood into the hole in the base of the wall unit (5) � check the position of the exhaust pipe and the electrical cable, press firmly so that the anchor springs (6) engage above the bottom of wall unit. Tighten the screws in the anchor springs firmly. � If necessary the hood can be fastened with four more screws (7). � Replace the grease filter support frame. � Replace the grease filter.
