5 star quality on these downloadable manuals. Easy to read and all the information is there. A must when doing a custom install or needing to service your precious old school electronics.
Please tell us what you think and share your opinions with others. Be sure to focus your comments on the product. You will receive $2.00 of store credit for Your review.
Text excerpt from page 14 (click to view)
INSTALLING THE COOKER HOOD
Drilling the Ceiling/Support Shelf
� Use a plumb line to mark the centre of the hob on the ceiling/support shelf. � Place the drilling template 21 provided on the ceiling/ support shelf, making sure that the template is in the correct position by lining up the axes of the template with those of the hob. � Mark the centres of the holes in the template. � Drill the holes at the points marked: � For concrete ceilings, drill for plugs appropriate to the screw size. � For hollow brick ceilings with wall thickness of 20 mm: drill ø 10 mm (immediately insert the Dowels not provided). � For wooden beam ceilings, drill according to the wood screws used. � For wooden shelf, drill ø 7 mm. � For the power supply cable feed, drill ø 10 mm. � For the air outlet (Ducted Version), drill according to the diameter of the external air exhaust duct connection. � Insert two screws of the following type, crossing them and leaving 4-5 mm from the ceiling: � For concrete ceilings, use the appropriate plugs for the screw size (not provided). � For Cavity ceiling with inner space, with wall thickness of approx. 20 mm, Screws not provided. � For wooden beam ceilings, use 4 wood screws (not provided). � For wooden shelf, use 4 screws with washers and nuts (not provided)
Fixing the Frame
� Loosen the two screws fastening the lower chimney and remove this from the lower frame. � Loosen the two screws fastening the upper chimney and remove this from the upper frame. If you wish to adjust the height of the frame, proceed as follows: � Unfasten the eight metric screws joining the two columns, located at the sides of the frame. � Adjust the frame to the height required, then replace all the screws removed as above. � Insert the upper chimney stack from above, and leave it running free on the frame. � Lift up the frame, �t the frame slots onto the screws up to the slot end positions. � Tighten the two screws and fasten the other two screws provided with the hood.
