|
Who's Online
There currently are 6041 guests and 2 members online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
I liked the product. I would use their sevices again.
;
I Recently purchased yet another Service Manual from Owner-Manuals.com, this time for a Sony EVS700ES/UB Videocassette Recorder. The Manual was available for upload within two hours and is an Extremely Good copy, as some of this I was able to enlarge to get even better detail.
Once Again, Very happy with the result!
;
A good and useful manual. With these, We was abled to isolate and pin point the component that was causing the problem. The total time spent in troubleshooting is very much reduced.
;
The quality of the manual is top. The transfer worked perfect and fast.
No problems at all. Recommendable
;
Very good service for get any documentation. Fast and perfect quality.
CH-X400/CH-X450
Removing the top cover
1. Pull out the dampers, being careful not to damage. When reattaching a damper, insert your finger to push out the center of the damper to mount it on the damper shaft, as shown in Fig. 6-1. 2. Turn the damper spring bracket toward the top at a right angle as shown in Fig. 7, then push down the lower side of the damper spring bracket to lift it off. 3. Remove the three fixing screws (3) and (4) on the DIN jack PCB assembly. 4. Lift the changer unit upward. 5. Remove the damper springs from the mechanism chassis if required. To reassemble, refer to the diagram below.
Fig. 5 Apply alcohol to the shaft then immediately attach the damper. (After attaching, check that the shaft is correctly inserted.)
Fig. 6-1
Push out with your finger before attaching
Lift the changer unit upward
Fig 6 Turn to the top position (at a right angle), then push down to lift off.
Fig. 8 Fig. 7 4 Remove the flexible ribbon wire if required Mechanism Chassis Silver (mechanism side) Red (magazine side) 4
How to attach the damper springs Fig. 8-1 Fig. 9 3
1-6
|
|
|
> |
|