|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I'm happy. Good quality. Very helped me with my work..............................
 ;
This is the second Manual I have ordered from owner-manuals, I give it five stars because it is exactly what I expected given the age of the equipment. So the contents look a bit aged and the pictures a bit grainy, it fulfills my needs and I am glad I can still get hold of them.
 ;
thank u so much for this manual that was so cheap that i thought it was a scam but i gambled anyway because it was too good of a deal to pass up and behold,the manual has everything and details of everything even the screws and im still amazed and very happy with my manual .so take my word and jump on it before they realize how cheap they selling thier manuals..thank you so much for taking time to read my thoughts
 ;
I do not have very much to say.
The price is quite covenient, delivery was better as promised (about 12 ours, against the specified 24 hours if I remember well), and the quality of the PDF is more than acceptable.
The Service Manual of Sansui R30 itself is also satisfactory: good graphic for schematics and layouts, simple and well structured.
Giovanni Bianchi
 ;
Happy to find finally a schematic for this amplifier. The schematic is of good quality, the pcb layout is useless: all is black. Never the less, it is very easy to find the components on the board using the schematics.
CH-X470RF Mounting the front slider and rear slider (See Fig.45 and 46)
1. Position the unit with the rear side facing down, then rotate the third gear in the direction of the arrow (clockwise) until the lift arm comes to the position at which the holes are exposed, as shown in Fig. 45-1. 2. Mount the front slider from the top. Rotate the third gear counterclockwise until the hole of the slider is lined up with the right hole of the stud, as shown in Fig. 45-2. 3. Mount the E-washer on the shaft. 4. Position the unit with the front side facing down, then mount the rear slider. Check that the u, v and w positions are correctly mounted as shown in Fig. 46. 5. Rotate the third gear in the direction of the arrow (counterclockwise) until the lifter unit is at the top position.
Rotate the third gear to move the slider Stud
Front slider
E-Washer
Position so that the stud and right hole are lined up
Check after mounting
Fig. 45-2
Fig. 45
Fig. 45-1
Set so the holes are exposed Rotate until the holes are lined up
u
v
w
Rotate the third gear to move the slider
Fig. 46
1-16
|
|
 |
> |
|