|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Ottimo manuale, grafica ferfetta invio rapidissimo. Altissimo livello!!!!!
;
Great PDF easy to read good info needed for replacment of belts and assembly and specs.
;
complete and unabridged very good quality
easy to download.
recieved in two days.
;
Awesome manual. Complete diagrams of all board assemblies as well as how to get to each part of the t.v. down to the individual screws and their locations. Get it.
;
perfect copy, im very satisfied, i was need the diagram over the powersupply and
the copy was very sharp
Madrigal Audio Laboratories P.O. Box 781 Middletown, CT 06457-0781 (860) 346-0896 FAX (860) 347-6251
TECHNICAL SERVICES
INFORMATION SHEET
5.1 / 7.1 AMPLIFIER OSCILLATION
Page 1 of 1
MARCH 17, 1999
OVERVIEW
There have been reports of 7.1 and 5.1 amplifiers shutting down when connected with 4-conductor speaker cable. The configuration of cable is frequently used to drive the 5.3 and 7.3 dual feed surround speakers. Citation amplifiers are ultra-wide bandwidth circuit designs. When this design is connected to long lengths of 4-conductor speaker wire, the output of one channel may leak into the ground of the ground of the adjacent channel through the cable, causing an amplifier to oscillate and go into protection. This is caused by the proximity of multiple conductors within a single wire sleeve.
PARTS
A 22uf capacitor needs to be installed between the negative terminals of the amplifier. The diagram below shows the location.
INSTALLING
Below is a diagram that shows how to connect the 22uf capacitor. If you should have further questions regarding the hook-up of these devices, please contact the customer support department at (860) 346-0896.
22uf capacitor connects between the negative of each pair of channels.
Speaker wire connection should be hooked up as usual.
51-71 AMP Oscillation-CIT31799.doc DOC# CIT31799
Page 1 WB-TS / FB-DW
|
|
|
> |
|
