This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
Text excerpt from page 8 (click to view)
Mounting of cooker hood in a cupboard, Alt. 1 (Fig. 6):
Cut an opening and drill 4 holes in the underside of
B A C 2 1
the cupboard. Use the template printed on the packaging. � Mount the locknuts (A) on the cooker hood. �Mount the cooker hood with four screws (B) and washers (C).
Fig. 6
Mounting of cooker hood in a cupboard, Alt. 2 (Fig. 7):
Cut an opening in the underside of the cupboard. Use the template printed on the packaging. � Mount the cooker hood with two screws (A) and the spacers (B). � Fit the plastic covers (C).
B A C
Fig. 7
Mounting of cooker hood between cupboards (Fig. 8):
Fit the two brackets (A) on the cooker hood. � Mark out the exact location to drill in the sides of the cupboards. � Mount the cooker hood with four screws (B), washers (C) and the nuts (D).
D A
C
B
Fig. 8
Mounting of cooker hood on wall (Fig. 9):
Mark out where the 4 holes shall be drilled on the wall. Drill in the markings with an �8 mm drill and fit rawl plugs into the holes. Use the template printed on the packaging. � Fix the screws (A). Leave about 5 mm distance between the screws and the wall. � Hook the cooker hood on the screws (A). � Remove the grease filter and mount the screws (B) in the two lower holes. Remove the grease filter by pulling it backwards (against the wall) and then downwards. � Tighten the screws (A). � Mount the grease filter.
36
C A