|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This is a great manual. It was easy to read and very accurate. The size of the manual is small so email is no problem. I highly recommend it. The manual is very hard to find other than this website.
;
Manual was complete and available promptly, since I had lost my original manual. Very good response.
;
Whilst this is a photo copy, and some of the pages are a little askew, it was all readable and intact. A real bonus finding an old manual for a classic piece of kit that no other site had.
Great stuff.
;
excellent quality, contains circuits and scan quality, 110 pages
;
It was easy done, and I got exactly what I was looking for.
ASSEMBLY
7
� � � � � �
Press weld nut into rubber latch and install two latch hook assemblies to lower chute using screw, washer, and lock washer as shown. Tighten hardware securely. Raise and hold deflector shield in upright position. Place rear of chute over rear of mower deck opening. Push chute down and forward to guide extended edge of chute between discharge guard and mower deck. Hook front latch into tab hole on front of mower deck. Hook rear latch into flange hole on back of mower deck.
LOWER CHUTE (See Figs. 7A & 7B) Use Hardware - - GROUP "E"
LOCK WASHER SCREW
WASHER LATCH WELD NUT
CAUTION: Do not remove discharge guard from mower. Raise and hold guard when attaching lower chute and allow it to rest on chute while in operation.
FIG. 7A
DEFLECTOR SHIELD
FRONT LATCH
REAR LATCH
FIG. 7B
10
|
|
|
> |
|
