|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I am very pleased with the service manual for my RT-909. This was an easy purchase and great procuct, and much cheaper than other venues i had looked at. This web site is now listed in my favorites list. KEEP UP THE GOOD WORK. THANKS. J. BROWN
;
A very well written and easy to understand manual.
;
There was no problem at all.After paying i had to wait only a few hours,than i could
download the manual in best pdf-quality.
Thank You !
 ;
I found this service manual to be complete in every detail except for troubleshooting charts. It would be helpful if it had a set of troubleshooting charts; however it is a very good manual otherwise and for the price it is very well worth it.
;
Complete manual included schematics layouts and alignment procedure, clear to read and magnify, extremely pleased with manual and owner manual . com's service
CHAPTER 13 TROUBLESHOOTING
Code
E071
· · · · · · · ·
Cause The side A sensor (PS2) is faulty. The side B sensor (PS3) is faulty. The C sensor (PS4) is faulty. The signal plate is faulty. The drum motor drive system is subjected to an overload. The transfer drum locking mechanism is faulty. The DC driver PCB is faulty. The CPU PCB is faulty.
1101
1102
· · · · ·
Side A sensor (PS2) is faulty. Side B sensor (PS3) is faulty. The C sensor (PS4) is faulty. The signal plate is faulty. The drum motor drive system is subjected to an overload. · The transfer drum is not locked properly. · The DC driver PCB is faulty. · The CPU PCB is faulty.
1103
1104
1105
1106
1107
Timing of detection The falling edge signal of the signal plate to be detected by the side B sensor is generated 0.3 sec earlier after the falling edge signal of the signal plate D detected by the C sensor has been generated. The rising edge signal of the signal plate to be detected by the side B sensor is generated 0.3 sec earlier after the rising edge signal of the signal plate C detected by the C sensor has been generated. The rising edge signal of the signal plate C to be detected by the C sensor is generated 0.3 sec earlier after the falling edge signal of the signal plate detected by the side B sensor has been generated. The falling edge signal of the signal plate C to be detected by the C sensor is generated 0.3 sec earlier after the rising edge signal of the signal plate detected by the side B sensor has been generated. The rising edge of the signal plate to be detected by the side A sensor is generated 0.3 sec earlier after the falling edge signal of the signal plate C detected by the C sensor has been generated. The falling edge signal of the signal plate to be detected by the side A sensor is generated 0.3 sec earlier after the rising edge signal of the signal plate D detected by the C sensor has been generated. The rising edge signal of the signal plate D to be detected by the C sensor is generated 0.3 sec earlier after the rising edge of the signal l plate to be detected by the side A sensor has been generated.
COPYRIGHT © 1999 CANON INC.
CANON CLC1120/1130/1150 REV.0 MAR. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
13-343
|
|
|
> |
|
|
Parse Time: 0.389 - Number of Queries: 111 - Query Time: 0.12
