SONY CMT-ED2U
Owner's Manual

Step 1: Hooking up the system (continued)

Tip
If you use the system with the speakers detached, you may remove the four screws on the both sides of the unit. If you do, be sure to retain the screws for future use.

6 Connect the power cord to a wall outlet.
If the plug does not fit the wall socket, detach the supplied plug adaptor (only for models equipped with an adaptor).

+ �

Note
Do not attempt to lift up the system by the speakers. There is a chance the unit will detach and drop. To move the system, detach the speakers first and carry them separately.

To replace the speaker grille
To remove the speaker grille, grasp one of the corners and lift the grille out towards you. You can replace the grille with one of the other supplied grilles of a different color. Verify which sides of the grille are rounded, then attach the grille with the rounded sides on the top and the bottom.

Note on the glass door of the CD player
The CD player door is made of tempered glass. Under normal conditions, this tempered glass is more shock resistant and able to bear more weight than ordinary glass. This glass, however, may shatter if it receives a sharp blow or if it is scratched.

To remove the AM antenna
If noise is heard while listening to an AM station, remove the AM antenna from the rear panel and place the antenna outside. 1 Remove the rear cover. (see step 1 on the page 4). 2 Remove the AM antenna.

To detach the speakers
1 Slide the speakers in the opposite direction of the arrows of the illustration in �Attach the speakers� (see step 2-3 on page 5). 2 After detaching the speakers, pass the speaker cords through the speaker cord slot at the bottom of the speaker to prevent them from being damaged.

Slot

6