|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Complete manual with clear schematic diagrams and printed circuit board layouts of two variants of the headset and the transmitter an old and a new version.
Also shows how the headset and the transmitter is opened and how transmitter and receivers can be adjusted and where to measure.
I had no problems to repair the headset using this service manual.
 ;
Excellent printing quality. A complete and very useful manual with all details.
;
This is a great site. I placed my order and by the next am it was available for download. Had some problems with some missing copy on some pages. Once I brought the error to the OMC's attention, the issue was resolved. I'll come back again.
;
Mi spiace per non poter scrivere in inglese... ma sono veramente soddisfatto del servizio offerto. Grazie..!!
;
The quality of this manual is good. It has all schematics and setup information for both the MDS-B3 and the MDS-B4. The scan quality is quite good, all pages are readable, This service manual also contains scans of the operating instructions from the User manual.
STC POS GEAR SL
Note: DO NOT remove the STC POS Gear SL together with the STC Motor SL Ass�y (Stocker) (M3), always replace it alone. If they are removed at the same time and the gear in the stocker height becomes out of position. 1 washer 2 STC POS gear SL POSITIONING OF THE STC POS GEAR SL REQUIRED Note: Assemble the STC POS gear SL so that the mark c on the STC POS gear SL meets the mark b on the MA chassis SL S ass�y. c b
STC POS gear SL
MA chassis SL S ass�y
LDG PLATE CAM SL
1 washer 2 LDG plate cam SL Note: Never use nail when turning the emergency gear SL.Otherwise, the gear tooth may be broken. (Fig. G. 2) emergency gear SL (Fig. G. 1) d
INSTALLING THE LDG PLATE CAM SL
POSITIONING OF THE LDG PLATE CAM SL IS REQUIRED.
(1) Turn the emergency gear SL in the direction of the arrow as shown Note: Never use nail when e in Fig. G. 1 until it stops. turning the emergency (2) Assemble LDG plate cam SL so that the center of the LDG plate cam gear SL. SL, mark d on the LDG plate cam SL and the center of the shaft are Otherwise the gear aligned on one line as shown in Fig. G. 2. tooth may be broken. (3) Turn the emergency gear SL in revers until the marks d , e on LDG plate cam SL are almost aligened as shown in Fig. G. 3. (This operation is required to return to the mechanism in standby state.) emergency gear SL
d LDG plate cam SL
(Fig. G. 3)
18
 $4.99 CMT-LS1 SONY
Owner's Manual Complete owner's manual in digital format. The manual will be available for download as PDF file aft…
|
|
|
> |
|
