|
There are currently no product reviews.
 ;
OK?..manual is complet and helpfull... for repairing such a old and rare boombox like JVC PCM it is necessary...
;
Super Anleitung. Ordentliche Auflösung. Das ganze noch in Deutsch wäre zu schön. Alle Datenblätter sind sauber Kopiert und alle Leitungswege sind sauber ausgeführt
;
Thanks God for the internet and thanks for the service like this - proffessional solution on time.
;
About the service it's very fast and reliable. About the manual the quality is high enough to read even the tiniest details on the wiring diagrams so you can't ask much more than that, let it alone for a manual of a product from 20 years ago. Thank you, very satisfied.
;
The downloaded quality was as good as the orignial
Technical Manual
CONTROL 1X
EXPLODED VIEW
Screw, 3.5x10m/m Black Plated C1006X, Crossover Network Control 1X, (NOT for SALE)
EVA Gasket Black
Screw, 4x8m/m Black Plated Front Baffle, Black C1002X, Tweeter
Screw T4x35m/m Black Plated
Die-Cast Alum. Safety Ring, Black
C1004X, Metal Grille, Black
Nut, M5x0.8m/m Zinc Plated Nut, M4x0.7Px3t m/m Zinc Plated
C1003X 4 1/2" Woofer, Tweeter Diffuser
Washer Screw, 4x18m/m, Black Plated
Spring
C1005X, Logo Badge on Grille
TO SERVICE THE CONTROL 1X 1. 2. 3.
Remove the grille. Remove all (6) 1 3/8" Allen Head screws holding the front baffle to the enclosure. Separate the front baffle w/ drivers from the enclosure.
Grille Holding Ring, Black
DRIVER REMOVAL - both woofer and tweeter are bonded to the front baffle with adhesive. Unclip faston connectors from both woofer and tweeter. a) Woofer removal Remove all (4) machine screws; rear nut can be held by long-nosed pliers while screws are turned. Apply heat gun (750°) to area around woofer basket until adhesive softens enough to extract the woofer. b) Tweeter removal Remove both (2) Philips screws. Apply heat gun (750°) to area around inside of cavity until adhesive softens enough to extract the tweeter. After removal, take care not to lose or misplace the small clear plastic diffuser should it become dislodged. CAUTION: Too much heat applied in one area too long could warp the front baffle. DRIVER REPLACEMENT Both woofer and tweeter must have a bead of adhesive applied to the outer rim only upon re-assembly. Silicon Sealer or Rubber-to-metal cement is recommended.
00260
JBL Consumer Products, Inc. 250 Crossways Park Dr., Woodbury, New York 11797
08/00
C N T R O L 1 X
|
