|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very good manual. Plenty of service information including alignment instructions. Clear circuit diagram. Excellent, thank you.
 ;
Good morning, the service manual you sent me was perfect.
Your service and answering are excellent.
I recomend this service.
Best regards.
;
I had been looking everywhere for a proper service manual for this VCR. Everywhere else that has this available for download has a very light version. This is the full service manual with all aspects that would interest anyone looking for the service manual for the AIWA HV-MX100 Worldwide VHS VCR. Great quality (as always). A winner hands down. Best Quality.
;
Top quality manual. Covers all aspects you'd expect in a top quality service manual for this Panasonic VHS VCR. The manual resolution is high. Another top quality manual from the only site worth downloading manuals from! If you're looking for a manual for the PV-9662 VHS VCR, this is the one you'll want to get!
;
complete part-lists and pcb layout, schematic diagram is good enlargable,
Technical Manual
Control 1X/1Xtreme
EXPLODED VIEW
Screw 3.5x10m/m Black Plated C1006X Crossover Network Control 1X/1Xtreme (NOT for SALE) EVA Gasket Black Screw 4x8m/m Black Plated
Front Baffle Black
C1002X Tweeter
Screw T4x35m/m Black Plated
Die-Cast Alum. Safety Ring, Black
C1004X Metal Grille Black Nut M5x0.8m/m Zinc Plated Nut, M4x0.7Px3t m/m Zinc Plated
C1003X 4-1/2" Woofer Tweeter Diffuser Screw 4x18m/m Black Plated Washer Spring Control 1X - C1005X Control 1Xtreme - C10028X Logo Badge on Grille Grille Holding Ring Black
TO 1. 2. 3.
SERVICE THE CONTROL 1X/1XTREME Remove the grille. Remove all (6) 1-3/8" Allen Head screws holding the front baffle to the enclosure. Separate the front baffle w/drivers from the enclosure.
DRIVER REMOVAL � both woofer and tweeter are bonded to the front baffle with adhesive. Unclip FASTON connectors from both woofer and tweeter. a) Woofer removal Remove all (4) machine screws; rear nut can be held by long-nosed pliers while screws are turned. Apply heat gun (750°) to area around woofer basket until adhesive softens enough to extract the woofer. b) Tweeter removal Remove both (2) Phillips screws. Apply heat gun (750°) to area around inside of cavity until adhesive softens enough to extract the tweeter. After removal, take care not to lose or misplace the small clear plastic diffuser should it become dislodged. CAUTION: Too much heat applied in one area too long could warp the front baffle. DRIVER REPLACEMENT Both woofer and tweeter must have a bead of adhesive applied to the outer rim only upon reassembly. Silicon Sealer or Rubber-to-metal cement is recommended.
JBL Consumer Products, 250 Crossways Park Drive, Woodbury, New York 11797
Rev 0 2/2002
Control 1X/1Xtreme
|
|
|
> |
|
