|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Excellent printing quality. A complete and very useful manual with all details.
 ;
This is a great site. I placed my order and by the next am it was available for download. Had some problems with some missing copy on some pages. Once I brought the error to the OMC's attention, the issue was resolved. I'll come back again.
 ;
Mi spiace per non poter scrivere in inglese... ma sono veramente soddisfatto del servizio offerto. Grazie..!!
 ;
The quality of this manual is good. It has all schematics and setup information for both the MDS-B3 and the MDS-B4. The scan quality is quite good, all pages are readable, This service manual also contains scans of the operating instructions from the User manual.
 ;
Quick site processing. A complete and very useful manual with all details. Thank you!
SERVICE MENU
To display the OSD for �SERVICE MENU� set up.
������� ��������������������� �������� ������� ������������ �������� ���� ���������� �����������
������������� �� ���������������
By the control panel 1. Display the menu by the �MENU� button. 2. Select the �OPT.� on the menu. 3. Continue press the button � � first, then press the button � � together with �RESET�, and hold for 3 seconds.
By the remote control transmitter 1. Display the menu by the �MENU� button. 2. Select the �OPT.� on the menu. 3. Continue pressing the button �MAGNIFY OFF� for 3 seconds.
Setup of a Cooling Fan Speed
When using this projector in the place where altitude is high, we recommend you to set a cooling fan�s speed as �HIGH�. It is because the cooling efficiency of a projector falls and the temperature inside a projector rises easily in such a place, since the density of air becomes low.
Setting Method of Cooling Fan Speed
1. Select the �FAN SPEED� on the OSD using button � � by the SERVICE MENU.
���������������������� ������������������������
��������
������
����
���������������������
2. Select the �HIGH� on the OSD using the button � �. To reset this setup, select the �NORMAL� using the button � �. 3. The OSD will be ended by no operation for 10 seconds or change of input signal. To end immediately, use one of buttons except buttons � �, � �, � �, � �.
NOTE:
The �HIGH� mode makes the fan noisy than �NORMAL� mode. The recall of factory setting sets the fan speed to �NORMAL� mode. You must set the fan speed after recall of factory setting if you need �HIGH� mode.
28
|
|
 |
> |
|