|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I'm very satisfied with your manual service. Your website made it easy to locate the correct manual. Also the quality is great and I never had a problem reading the fine details.
Thanks again.
Jeff Miller
JM Electronics
 ;
Good quality service manual German user manual. German user manual This is a quality scan of a manual in excellent condition and is just as good as having the original manual in hand
;
The manual for Sony LBT-D505 component stereo system is was excellent , with schematics, parts layout and parts list as well as instructions for adjustments for each component. Print was clear even when enlarged.
;
It's exactly a complete and very useful manual with all details what I needed. Thank you!I will come back whenever I need your manuals or schematics.
;
I searched EVERYWHERE looking for the manual/s on this "extinct" amp. Owner-Manuals.com made it available and for nearly nothing. Thanx to them, I can decipher the unknown cables and sort them out. Thanx, Owner-Manuals.com!!
CD-K7000W/C7000W,CP-C7000
How to remove the belt (TAPE 1) (See Fig. 13-1)
1. Remove the main belt (D1) x 1 pc., from the motor side. 2. Remove the FF/REW belt (D2) x 1 pc.
How to remove the belt (TAPE 2) (See Fig. 13-1)
1. Remove the main belt (E1) x 1 pc., from the motor side. 2. Remove the FF/REW belt (E2) x 1 pc.
How to remove the motor (See Fig. 13-2)
1. Remove the screws (F1) x 2 pcs., to remove the motor.
Motor
Motor TAPE2 FF/REW Belt (E2)x1 Motor TAPE2 Main Belt (E1)x1 TAPE1 Main Belt (D1)x1
(F1) x2
�2.6x5mm
TAPE1 Main Belt FF/REW Belt (D2)x1
Figure 13-1
Figure 13-2
CD MECHANISM SECTION
Perform steps 1, 2, 3, 13 and 16 of the disassembly method to remove the CD mechanism.
Loading Motor
How to remove the loading motor (See Fig. 13-3)
1. Bend the hooks (A1) x 5 pcs., to remove the loading motor.
(A1)x2
(A1)x1 (A1)x2 CD Base
Figure 13-3
How to remove the pickup (See Fig. 13-4)
1. Remove the stop washer (B1) x 1 pc., to remove the gear (B2). 2. Remove the screws (B3) x 2 pcs., to remove the shaft (B4). 3. Remove the pickup. Note After removing the connector for the optical pickup from the connector wrap the conductive aluminium foil around the front end of connector so as to protect the optical pickup from electrostatic damage.
Stop Washer (B3) x2 ø2.6 x6mm (B1) x1
Pickup Shaft (B4) x1 Gear (B2) x1
Figure 13-4 � 13 �
CD Mechanism
|
|
|
> |
|
