|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
;
Well Well Well!!!! Good manual perfect for my hobby!!! As Before you have done a very well done work!!!! Thank you
;
Super nice! Good to have a manual in digital format.
;
Great job supplying the manual.
Many of these products weerepretty obscure, so it was great that you had
the manual for it!
;
Great manual, would not have been able to operate my machine without it!!
James Dawson August 18, 2012
Assembly and Installation 1
Remove base
Using the provided Allen wrench, remove the three base screws and then the base from the speaker. Save these screws and the base if there is any chance you will want to replace the bases for ordinary floor installations in the future.
4
Temporary mounting
NOTE When the mounting fixture is combined with the speaker system S-VSL3, the total weight is about 10 kg. The installation technician should decide on the optimum mounting method based on an assessment of the wall�s materials and structure. � Confirm the height from the floor. Enough space must be left between the floor surface and the speaker body to allow the introduction of a screwdriver in order to install and tighten the terminal cover.
70
76.6 962.6
Hole for temporary mounting (� 5.5)
Using the furnished 3 mm Allen wrench, remove the four screws from the top of the speaker. Place the upper plate on the speaker top and use the 3 mm Allen wrench to tighten the removed mounting screws.
Consult the dimensional diagram on P. 9 for external dimensions following speaker installation.
85
Floor
5
Since the hex holes in the mounting screws are rather shallow, be sure to hold the Allen wrench securely to prevent slipping, and tighten the screws securely to prevent slipping.
Mark the position of the mounting screws
Use a level or plumb bob to confirm the perpendicular, and mark the position of the mounting screws on the wall. The mounting screws should have a diameter of 4-5 mm (5 mm is recommended) in 6-8 locations. The safety strap location and mounting screw diameters should be 1 screw of 5-6 mm in the upper square hole (6 mm is recommended); bushing location and screw diameters are 2 screws of 5-6 mm (6 mm recommended) within the 9x15 rectangular hole.
3
Fasten the safety strap to the speaker
Temporarily remove the mounting fixture on the rear of the speaker, place around the safety strap and once again fasten the mounting fixture to the speaker.
Safety strap
1055.6
2
Attach upper plate
7 En
English
|
|
|
> |
|
