|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Incredibly clear!!!! Well done, complete and wonderful. It could not better than this!!!!
 ;
Thank You for fast delivery for the sheme.
Everything allright.
Thanks & best regards Franz
;
again you did a very good job. It was fast too. Photocopy are really readable and clear
;
Probably it never existed a 1081 official service manual from Commodore, it's look more like a NAPCEC service manual & diagrams compilation of the 1084 series and his variants, like the nap6523, 8cm505, 1084S, 1084P and obviously the 1081. It's more complete than other scans and the quality of the scans also are far superior. It has two circuit diagrams variants of the 1081, mono and stereo versions. It doesn't include a diagram for the Philips CM8500 or CM8501, they look like the 1081 but they are slightly different.
;
Rapid, clear well done as all the scheme I downloaded from this site. Great job very functional and very useful
(3) Wiring of the power board block (for assembling the board block sub assembly) (a) Wiring of the ballast block before it is placed on top of the power board.
Connect the CNPWR to the CN1 connector, and make sure that it is perfectly locked. Power board
CNPWR
CN1
(c) Outline of the ballast board after it has been placed on top of the power board.
Squeeze the CNPWR cables into the left hand side of the power block before connecting the power air intake fan, also make sure that the CNBAR cables have been passed through the ballast holder slots.
CP-X1200(P5XLA) / CP-X1250(P5XMLA) / CP-X1200WA(P5XMLB)
Ballast board
CNBAR
Power air intake fan #3054
30
(b) Wiring of the ballast board when it is placed on top of the power board.
Pull the CNPWR cables to the left (in the direction of the arrow in the diagram below), when placing the ballast board on top of the power board. (The cables may come into contact with the spinning blades of the power air intake fan to the right.) Ballast board
CNTH #3054 leads CNBAR
Make sure that the CNBAR does not droop on top of the ballast board. (Maintain a safe distance.) (Prevents the CNBAR from coming into contact with the fan blades.) Make sure that the lines do not protrude from the notch of the ballast cover. (Prevents tangling.) Power board
CNBAR Lamp leads
Connect the CNTH cable to the E950 sensor board's connector.
Run the lamp leads in the power block's grooves.
Wiring diagram 2 (P5XLA/P5XMLA/P5XMLB)
|
|
|
> |
|
