|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Good service manual,i saved from scrapping this deck,is now fully functional.Thanks.
 ;
Found this to be the manual included with the original packinging, was helpfull but did not give any detailed repair instructions.
;
Complete service manual, was very helpful in repairing this tapedeck.Thanks.
;
The service manual was a copy of the original from Wirlpool. The quality was good, all neccecary information was available including the service-codenumbers, so I could order the right part to be replaced for repair.
Downloding was no probem after the payment.
Thanks for the service!
;
Good,readable manual. I found other manuals that were not readable when it came to part ID, but the one downloaded from owner-manual.com was better than expected. I will do buisness with owner-manual.com again.
(3) Wiring of the power board block (for assembling the board block sub assembly) (a) Wiring of the ballast block before it is placed on top of the power board.
Connect the CNPWR to the CN1 connector, and make sure that it is perfectly locked. Power board
CNPWR
CN1
(c) Outline of the ballast board after it has been placed on top of the power board.
Squeeze the CNPWR cables into the left hand side of the power block before connecting the power air intake fan, also make sure that the CNBAR cables have been passed through the ballast holder slots.
CP-X1200(P5XLA) / CP-X1250(P5XMLA) / CP-X1200WA(P5XMLB)
Ballast board
CNBAR
Power air intake fan #3054
30
(b) Wiring of the ballast board when it is placed on top of the power board.
Pull the CNPWR cables to the left (in the direction of the arrow in the diagram below), when placing the ballast board on top of the power board. (The cables may come into contact with the spinning blades of the power air intake fan to the right.) Ballast board
CNTH #3054 leads CNBAR
Make sure that the CNBAR does not droop on top of the ballast board. (Maintain a safe distance.) (Prevents the CNBAR from coming into contact with the fan blades.) Make sure that the lines do not protrude from the notch of the ballast cover. (Prevents tangling.) Power board
CNBAR Lamp leads
Connect the CNTH cable to the E950 sensor board's connector.
Run the lamp leads in the power block's grooves.
Wiring diagram 2 (P5XLA/P5XMLA/P5XMLB)
|
|
|
> |
|
