|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
PDF Contains
Technical Data, Mechanical data, Detailed Circuit diagram with components value, PCB layout. Actual PCBs Print. Component List, Spare parts code list and Input output detail. It cover LBB1211, LBB1212, LBB1213, LBB1216, LBB1217.
It is the actual Service Manual for SQ10
;
very good manual with clear electrical schemes. Very helpful to find wat was wrong inside my microwave.
 ;
Hi, thankyou for providing the Nordmende Globetrotter original manufacturer's repair manual. Quality is very good and sharp - the PDF file was comfortably small to download. The only question is: why did it take so long to become ready for download?? Many thanks anyway, I fixed the fault in the radio thanks to the circuit.
regards: Nick
;
This was super service.Ordered this manual and was reading the download an hour later
;
as always, rapid and efficient, very good and clear prints
details clearly visible keep going this way!!!!!!
Wiring of the circuit power supply (2/2) Wiring of the circuit power supply board (1)Style the CNPOW, TSW, and FG3. (2)Attach the CNSH2 (3)Attach the power supply sheet. (4)Style the CNPWR.
TSW Fastener
Lock the CNPOW, TSW, and FG3 by passing them through the power supply case fastener.
Make sure to pass the CNSH2 through the hole indicated in the diagram below. [CAUTION] Make sure to attach the power supply sheet after attaching the CNSH2.
Power supply case
CNPOW
FB5
Pass the CNPWR through the hole in the power supply sheet, and pull the wire out. When pulling out the CNPWR and FB2, make sure that they do not pass over the C104 (electrolytic capacitor), as this will cover the anti-explosion valve on the top of the capacitor.
View from above
C104
CN102
FG3 Power supply sheet CN103 C104 FG1
FB1
CP-S240(CC9SM)/CP-X250(CC9XM)
Circuit power supply
CN101 FB2 CNSH2
E2
31
View from the side
C104
Fasten the CNSH2 and E2 with tape, ZTP1 and ZTP2, after passing them through the clamps of the power supply case. [CAUTION] As the upper case touches the gray areas of the diagram on the right, make sure no wires protrude into these areas.
CNPWR
ZTP2
Clamp Clamp
Power supply sheet
Power supply sheet
C104
C104
Correct (solid line) Correct Incorrect
Louver of the power supply case Incorrect (dotted line)
Outline of power supply case holes
Don�t wire the E2 on the louvers. The solid line in the diagram indicates an example of correct wiring. The dotted lines in the diagram indicate examples of incorrect wiring.
ZTP1
Fasten the E2 with tape ZTP1. Make sure to stick the tape along the outline of the power supply case holes as shown in the diagram.
Wiring diagram 2
|
|
|
> |
|
