|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The manual was made available promptly. I is a clean scan of the original. I had no problem downloading it. The scan was well centered and cleanly formatted. It is as good a product as can be had without being the original document.
 ;
Received downlink in less then 8 hours, Item was in good copy condition, and told me how to program the clock timer. The price was very resonable, and the process was very automated and was GREAT to work with.
;
Fast service, document is OK. Thanks! Searched for it long time.
;
I was very pleased with the manual I got for my amateur (ham) radio. Without it I could not figure out how to input and/or change the P/L setting on my radio. It drove me nuts as the radio was essentially useless. That all changed when my manual came. Then it took only minutes and I was done. Now my radio works fine. This is an exceptionally good resource as it's a very easy and user friendly download. Thank you very much! Dziękujemy za!
;
It answered my question, which was how to load the paper. I did notice that the very end of the manual was not visible.
E N G L I S H 35
Installation Guide (continued)
Installation Procedures
First complete the electrical connections, and then check them for correctness. (page 56) Remove the mounting collar 1 and the trim plate 7 from the main unit temporarily, which are already mounted at shipment. 6 Power connector Mounting springs (§) The included mounting collar 1 is designed speci�cally for this unit. Do not use it to attach any other model.
Remove the Unit
Switch off the power of the unit.
E N G L I S H 36
1 Remove the removable face plate. (page 49)
Screwdriver
7 Trim plate
1 Insert mounting bend the mounting tabs out collar 1 into the dashboard, and
with a screwdriver. The tabs to be bent vary depending on the car. To securely install the unit, fully bend a number of the tabs so that there is no rattling. Example: Tab
2 Remove the trim plate 7 with a screwdriver. 3 1 Insert the lock cancel plates 8 along the
grooves on both sides of the main unit until �click� is heard. 2 Pull out the unit while pushing the plates further inside.
1 Insert. Insert the tab end in the outer groove.
2
5 Mounting bolt Mounting holes
Secure the rear of the unit. After �xing mounting bolt 5 and power connector 6, �x the rear of the unit to the car body by either method (a) or (b) shown below.
�Click�
8 Lock cancel plate
3 Insert trim plate 7.
2 Pull out. Engage the mounting springs (§) in the mounting holes of the mounting collar 1 �rmly. Mounting hole Mounting springs (§)
4 After installation,
negative - battery terminal.
reconnect the
4 Remove the unit pulling with both hands.
(a) Using the rear support strap 3
Fire wall of car 4 Tapping screw 3 mm·
(b) Using the rubber cushion (option)
Rear support bracket Rubber cushion (option) (provided on the car)
2 Hex. nut 3 Rear support strap 5 Mounting bolt 5 Mounting bolt 1 Mounting collar 1 Mounting collar
54
CQ-C5410/5310/5210/5110U
CQ-C5410/5310/5210/5110U
55
|
|
|
> |
|
