|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Thank´s for your help, I already recived these manual from you
;
Thank you for your manual It has the basic things to and i use the Oszi for Longer Time.
THX
;
Actually, I was looking for this information for 3 years!...now thanks to you, the manual is on my hands and of great help, cause I understand now where I was doing wrong connections and wires...excellent, I'll be back to you if in need, thank you.
 ;
This manual covers the main equipment features only. While it also includes the procedure for saving and loading from the now long obsolete memory cards it does not mention the how to operate with the optional floppy drive interface so I am still at a loss about how to use this! Note that there is a separate manual covering the MIDI interface and programming via the keyboard, not included in this download. You will also need to get hold of this if you want to use the MIDI interface properly. Basically there is little difference between this manual and the free to download manual for the similar PR60 model.
;
Good list of manuals. I found a very rare one and easily get. Should be promptly to download, as we must to wait hours even after confirmed payment.
E N G L I S H 35
Installation Guide (continued)
Installation Procedures
First complete the electrical connections, and then check them for correctness. (page 56) Remove the mounting collar 1 and the trim plate 7 from the main unit temporarily, which are already mounted at shipment. 6 Power connector Mounting springs (§) The included mounting collar 1 is designed speci�cally for this unit. Do not use it to attach any other model.
Remove the Unit
Switch off the power of the unit.
E N G L I S H 36
1 Remove the removable face plate. (page 49)
Screwdriver
7 Trim plate
1 Insert mounting bend the mounting tabs out collar 1 into the dashboard, and
with a screwdriver. The tabs to be bent vary depending on the car. To securely install the unit, fully bend a number of the tabs so that there is no rattling. Example: Tab
2 Remove the trim plate 7 with a screwdriver. 3 1 Insert the lock cancel plates 8 along the
grooves on both sides of the main unit until �click� is heard. 2 Pull out the unit while pushing the plates further inside.
1 Insert. Insert the tab end in the outer groove.
2
5 Mounting bolt Mounting holes
Secure the rear of the unit. After �xing mounting bolt 5 and power connector 6, �x the rear of the unit to the car body by either method (a) or (b) shown below.
�Click�
8 Lock cancel plate
3 Insert trim plate 7.
2 Pull out. Engage the mounting springs (§) in the mounting holes of the mounting collar 1 �rmly. Mounting hole Mounting springs (§)
4 After installation,
negative - battery terminal.
reconnect the
4 Remove the unit pulling with both hands.
(a) Using the rear support strap 3
Fire wall of car 4 Tapping screw 3 mm·
(b) Using the rubber cushion (option)
Rear support bracket Rubber cushion (option) (provided on the car)
2 Hex. nut 3 Rear support strap 5 Mounting bolt 5 Mounting bolt 1 Mounting collar 1 Mounting collar
54
CQ-C5410/5310/5210/5110U
CQ-C5410/5310/5210/5110U
55
|
|
|
> |
|
