|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This scanned manual is well done in that most all the pages except for one is straight and clear- the way I would do them. One page was upside down but that happens. For the money that is charged on this site you get a pretty good deal. Now with complex repairs, I still prefer to us paper manuals which I have to buy at stereomanuals but the one I got here was much less than the $45 he was charging but this is a larger than normal manual for three different units. I am a picky manual user because I have used original manuals from Sony and Teac.
;
Very useful service manual, was exactly what i needed.Good quality,reasonable price.Thank you.
;
Acurate informations inside the SM and I could repair my old Sansui SC-3330 without any problems. Thanks.
;
I used it to repair a NAD 7030, but unfortunately, the 7045 is different !
But documentation was useful.
;
Content A4 and A3 format pages. Exactly what I needed to restore my old receiver.
Adjusting the convergence (CONVERGENCE)
The CONVERGENCE settings allow you to adjust the quality of the picture by controlling the convergence. The convergence refers to the alignment of the red, green, and blue color signals. If you see red or blue shadows around letters or lines, adjust the convergence. These settings are stored in memory for all input signals.
Adjusting the picture quality (SCREEN)
The SCREEN settings allow you to degauss (demagnetize) the monitor manually and adjust the picture quality by controlling the moire and landing. � If the color is not uniform or picture is fuzzy, degauss the monitor (DEGAUSS). � If elliptical or wavy patterns appear on the screen, cancel the moire (CANCEL MOIRE). The monitor is automatically demagnetized (degaussed) when the power is turned on. The screen is degaussed for about 2 seconds. If a second degauss cycle is needed, allow a minimum interval of 20 minutes for the best result. The CANCEL MOIRE setting is stored in memory for the current input signal. All other settings are stored in memory for all input signals.
1 Press the MENU button.
The menu appears on the screen.
2 Move the control button up or down to highlight
CONVERGENCE and press the control button. The CONVERGENCE menu appears on the screen.
3 Move the control button up or down to select the
desired adjustment item. Then press the control button. The adjustment bar appears on the screen.
1 Press the MENU button.
The menu appears on the screen.
4 Move the control button up or down to make the
adjustment. Then press the control button. Select To horizontally shift red or blue shadows vertically shift red or blue shadows T TOP B BOTTOM 0 RESET vertically shift red or blue shadows at the top of the screen vertically shift red or blue shadows at the bottom of the screen reset all the CONVERGENCE adjustments to the factory setting levels. Select OK.
2 Move the control button up or down to highlight
SCREEN and press the control button. The SCREEN menu appears on the screen.
3 Move the control button up or down to select the
desired adjustment item. Then press the control button. The adjustment bar appears on the screen.
4 Move the control button up or down to make the
adjustment. Then press the control button.
For more information about using the RESET mode, see �Resetting the adjustments (RESET)� on page 18.
14
|
|
|
> |
|
