|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
the manual is in good quality and it's in pdf. manual was send in less then 24h.
regards
mike
;
I would not plug this machine in without finding a manual like this. In addition to setup and normal operating instructions, it has troubleshooting flowcharts, diagrammed mechanical adjustments, and schematics to beat the band. The tech I hand it to would be thrilled to find solder side PCB diagrams with component outlines superimposed, pinouts for every IC chip, and line drawings of transistors, with labeled legs.
As for printing quality, this may be a copy of a copy, but even the finest print when enlarged is very legible. There is a bit of grayed print over a few pages, as if a wet page were placed over it, but the print is still very legible. If you could borrow an original manual and get it printed and bound for 4 to 6 times the cost, you could get better quality. In that case you wouldn't be here. For price, utility, and availability I am rating this manual highly.
;
I received the Manual in a timely manner and it was exactly what I needed.
This is a perfect copy of the Service Manual, The quality is great. I am very
happy. Thank you
;
exactly as they say. Within 24 hours the link to the pages and offcourse it was the right service manual. Super and thanks
 ;
The manual was exact the thing that was promised. My old car stereo is working again thanks to the information supplied.
CR200
8-6. Typical Faults on CD-R
1. Signal skipping or interruption
� There are scratches, dusts and / or fingerprints on the disc. � The pickup is faulty. � Misalignment (Screw, etc.).
2. Signal skipping or interruption occurs when the disc is recorded and then played back on the same CD-R unit.
� The recording power is too low. � The pickup is faulty. � Some of the section on the disc where dusts were attached could not be properly recorded.
3. SEARCH operation cannot be executed.
� AC voltage is too low (-15% or more). � The gear in the servo mechanism is faulty (scratches, etc.). � Misalignment (Screw, etc.). � The pickup is faulty.
4. The unit cannot be put into REC-PAUSE mode.
� The recording power is too low. � The pickup is faulty.
5. The tray cannot be open.
� There are scratches or dusts on the FG detection photo reflector pattern attached to the bottom side of disc table. � The wires inside the unit get entangled. � The oil put in the loading mechanism is too less.
91
|
|
|
> |
|
