|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Great quality complete service manual! complete parts list and drawings. Thanks!
;
Great quality complete service manual! complete parts list and drawings. Thanks!
;
Very good quality, prompt response. This website has reasonable prices and wide range of manuals that are hard to find.
;
The document was usefull, and it was exactly what I was looking for.
;
OK?..manual is complet and helpfull... for repairing such a old and rare boombox like JVC PCM it is necessary...
6. Replacement of battery for memory protection (for CS-4194H (ACO))
Time for battery replacement
Replace with a new battery once 2 year.
7. Resetting the unit (for CS-4194H (ACO))
Strong impacts, exposure to electrical fields, or other unusual conditions may render the unit inoperative, and pressing the keys will have no effect. If this occurs, you will have to press the RESET switch on the bottom of the unit. The RESET switch should be pressed only when: � an abnormal event occurs and all keys are disabled. � you install or replace the battery.
Method of battery replacement
Use one lithium battery (CR2032). Note: When replacing the battery, the set tax rate and the memory contents will be lost. You may want to write down the tax rate and other important numbers on a sheet of paper. 1. Turn the power switch �OFF� and unplug the power supply plug from the outlet. 2. Remove the battery cover on the back of the unit. (Fig. 1) 3. Remove the exhausted battery and install one new lithium battery. Wipe the battery well with a dry cloth and place the plus �+� side upward. (Fig. 2) 4. Replace the battery cover by reversing the removal procedure. 5. Press the RESET switch on the back of the unit.
Note: � Pressing the RESET switch will clear the stored tax rate and other data stored in the memory. � Use only a ballpoint pen to press the RESET switch. Do not use anything breakable or anything with a sharp tip, such as a needle. � After pressing the RESET switch, connect the power supply plug to an outlet. Turn the power switch �ON� and check that �0.� is displayed.
1
2
Fig. 1
Fig. 2
After battery replacement
� Connect the power supply plug to an outlet and turn the power switch �ON�. Check that �0.� is displayed. If �0.� is not displayed, remove the battery, reinstall it, and check the display again. � Reset the tax rate. � On the battery replacement date label found on the back of the unit, write down the month and year when the battery is replaced, as a reference for the next battery replacement.
Precautions on battery use
� Do not leave an exhausted battery in the equipment. � Do not expose the battery to water or flame, and do not take it apart. � Store batteries out of the reach of small children.
Notes for handling Lithium batteries:
CAUTION Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer. Dispose of used batteries according to the manufacture�s instructions.
CS-4194H Replacement of battery for memory protection (for CS-4194H (ACO))
�4�
|
|
|
> |
|
