|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The manual was well-scanned and easy to read. As an added bonus, the Operator's Manual was bundled with the Service Manual!
I'd definitely use owner-manuals.com again.
;
Finally, i found one website, where i can download this service manual , and fix my hifi. The service manual is very good, and easy to download and to print.
 ;
Complete and very useful. Could have benefited from a little higher resolution on the schematic and layout diagrams for improved legibility.
;
Great Service Manual, Very Complete, as advertised, Perfect, Thanks!
;
Good quality service manual.It has helped me to fix my FV1800,particularly for replacing the dial cord.The scheme is on A3 format and very readable.Thank.Olivier.
1. Degauss the CRT and allow CRT to operate for 20 minutes before starting the alignment. 2. Set the screen control to minimum position. Input the Black raster signal from RF input. 3. Enter the Service mode. (See page 1-6-1.) Dimmed horizontal line appears on the CRT. 4. Press the [VOL p] button. (Press [VOL p] button then display will change CUT OFF/DRIVE adjustment). 5. Choose CUT OFF/DRIVE mode then press [1] button. This adjustment mode is CUT OFF (R). 6. Press the [CH o / p] buttons until the horizontal line becomes white. 7. Choose CUT OFF/DRIVE mode then press [2] button. This adjustment mode is CUT OFF (G). Press [CH o / p] buttons until the horizontal line becomes white. 8. Choose CUT OFF/DRIVE mode then press [3] button. This adjustment mode is CUT OFF (B). Press [CH o / p] buttons until the horizontal line becomes white. 9. Input the White Raster Signal from Video In. 10. Choose CUT OFF/DRIVE mode then press [4] button. Adjust the RED DRIVE as needed with the [CH o / p] buttons to get the following value, X = 286, Y = 294. 11. Choose CUT OFF/DRIVE mode then press [5] button. Adjust the BLUE DRIVE as needed with the [CH o / p] buttons to get the following value, X = 286. 12. Turn the power off and on again.
10. Sub-Brightness Adjustment
Purpose: To get proper brightness. Symptom of Misadjustment: If Sub-Brightness is incorrect, proper brightness cannot be obtained by adjusting the Brightness Control. Test Point --Tape --Adj. Point [CH o / p] buttons M. EQ. Pattern Generator Figure Mode --Input SMPTE 7.5IRE Spec. See below
White
Black This bar just visible
Fig. 5
Note: SMPTE Setup level --- 7.5 IRE 1. Enter the Service mode. (See page 1-6-1.) Then input SMPTE signal from RF input. 2. Press [MENU] button. (Press [MENU] button then display will change BRT, CNT, COL, TNT and V-T.) Select BRT and press [CH o / p] buttons so that the bar is just visible (See above figure). 3. Turn the power off and on again.
1-6-5
T5517EA
|
|
|
> |
|
