|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
High quality scan of the manual, very quick and easy download and very important, a truly honest price. thanks
 ;
Minden rendben, de két megjegyzés, az ábrák nehezen kivehetők és a fizetés után 24 órát kell várni a letöltésre.
;
Manual correct, and complete. Downloads cleanly. Format of manual was presumably difficult to PDF to A4, but works reasonably well.
;
This was a hard to find manual. When I did find it , some sites wanted way too much for the file.
Owner-manual .com had it for a really reasonable price. Not only that but it was sent very quickly and was a quality scanned document, unlike some others I purchased from a different site.
Good job guys!!
Larry
;
Fast and courteous service. Product delivered as described. Thank you.
Surface
To Install
Burner
Burner
Module
Module
]
1. Be sure all control knobs are turned off. 2. If the grill burner before installing burner basin of Cook-top Cleaning grates are in place, remove them a surface burner module. Clean any grease accumulation (See Chart, pp. 10-11).
Grill Module
The grill consists of two black grill grates and a grill burner. Only install the grill on the left side of your eooktop.
3. Position the burner assembly with the mixer tube assembly toward the orifices until the opening for the ignitor is over the ignitor. Lower into place until the side openings are resting on the burner supports and the ignitor is centered between the two flash tubes. 4. openings aeration tray by inserting the prongburner Install the toward the orifiees. Slide the at the end of the tray into tile opening in the end of the burner basin. Lower the opposite end into the eooktop. NOTE: Before first use, read "Surface Cooking" and "Cleaning Chart--Surface Burner Assembly" pages 7 and 11. Burner Module _ _I _!_ l
To Install
Grill
Module be certain control
1. Before installing grill components, knobs are in the OFF position.
To Remove
'2. Position the grill burner with mixer tube openings toward the orifices. Slide the burner towards the orifices until the ignitor is in between front and rear grill sections. Lower into place until side openings are resting on fi_e burner support pins. 3. Place the grill grates on the top of the cooktop.
1. The control knobs should be in the OFF position and the eooktop should be cool 2. Remove the aeration tray by lifting up the front end on the right side (back end on tile left side) until the top clears the opening of the eooktop by about 5 inches. 3. Hold aeration tray by the sides and slide away to remove the prong from the opening and clear the surface burners. 4. Lift up on the sides of the surface burner assembly bracket about 2 inches. Slide away from the orifices.
To Remove
Grill
Module
1. Remove grill components once they are cool. Be sure control knobs are in the OFF position. 2. Remove grill grates. 3. Remove grill burner. =AGE 6
|
|
|
> |
|
|
Parse Time: 0.266 - Number of Queries: 110 - Query Time: 0.062
