|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The manual was made available promptly. I is a clean scan of the original. I had no problem downloading it. The scan was well centered and cleanly formatted. It is as good a product as can be had without being the original document.
 ;
Received downlink in less then 8 hours, Item was in good copy condition, and told me how to program the clock timer. The price was very resonable, and the process was very automated and was GREAT to work with.
;
Fast service, document is OK. Thanks! Searched for it long time.
;
I was very pleased with the manual I got for my amateur (ham) radio. Without it I could not figure out how to input and/or change the P/L setting on my radio. It drove me nuts as the radio was essentially useless. That all changed when my manual came. Then it took only minutes and I was done. Now my radio works fine. This is an exceptionally good resource as it's a very easy and user friendly download. Thank you very much! Dziękujemy za!
;
It answered my question, which was how to load the paper. I did notice that the very end of the manual was not visible.
Positioning and Connecting the Set
5 cm
5 cm
5 cm
Positioning Position your set so that no bright light or sunlight falls directly onto the screen. Otherwise the brilliance of the picture will be affected by reflections. The air vents on the back of the set must be kept clear at all times to allow the set to cool. Leave enough room at the back if you stand your set on a shelf or in a cabinet.
Connecting To the mains Plug the TV�s mains plug into a socket. The set will operate on 195 to 260 volts AC, 50 or 60 hertz.
To the antenna Connect your set to the antenna as shown opposite with a coaxial antenna cable (75 ohms).
Connecting a video recorder Connect the coaxial antenna cable to the antenna socket (aerial) of the recorder. Connect the output of the video recorder (RF-Out) to the TV�s antenna input (VHF/ UHF) with a second antenna cable.
Safety Instructions � If the set is moved from a cool environment to a warm room, do not switch it on until it has been given reasonable time (about 1 hour) to warm up. � The set is designed for the home and office and may not be used in rooms with a high humidity or concentration of dust. � Make sure the set stands firmly when placed on a shelf, a table or in a cabinet. � Position the set so that it is not exposed to direct sunlight and additional heat from radiators. � The slits in the rear panel are for cooling of the set and should never be covered up with mats or curtains. � Make sure no metal parts, pins, paper clips, liquids or wax are dropped or spilt through the ventilation slits in the back of the set. If this should happen, switch off the the set immediately with the On/Off switch and pull out the mains plug. � Never remove the rear panel from the set. Only have the set repaired by the service technician. � In case of imminent thunderstorms, pull out the mains plug and the antenna plug from the socket to protect your set.
ARIAL
RF�OUT
7
 $4.99 CT1170 LOEWE
Service Manual Complete service manual in digital format (PDF File). Service manuals usually contains circuit diagr…
|
|
|
> |
|
