|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The manual was made available promptly. I is a clean scan of the original. I had no problem downloading it. The scan was well centered and cleanly formatted. It is as good a product as can be had without being the original document.
 ;
Received downlink in less then 8 hours, Item was in good copy condition, and told me how to program the clock timer. The price was very resonable, and the process was very automated and was GREAT to work with.
;
Fast service, document is OK. Thanks! Searched for it long time.
;
I was very pleased with the manual I got for my amateur (ham) radio. Without it I could not figure out how to input and/or change the P/L setting on my radio. It drove me nuts as the radio was essentially useless. That all changed when my manual came. Then it took only minutes and I was done. Now my radio works fine. This is an exceptionally good resource as it's a very easy and user friendly download. Thank you very much! Dziękujemy za!
;
It answered my question, which was how to load the paper. I did notice that the very end of the manual was not visible.
Connections
Refer to the figure shown below to connect the CUBE-30X to other equipment.
fig.01-02
Footswitches
If using a FS-6 switch, set the MODE and POLARITY switches as shown below.
FS-6 FS-5U FS-5U FS-5U
Recorder
B
A
EFX
SELECT
EFX
SELECT
SELECT
red
white
Stereo 1/4� phone plugs at both ends
PCS-31
CD/MP3 player Electric Guitar
Switching the Power On and Off
Once the connections have been completed, turn on power to your various devices in the order specified. By turning on devices in the wrong order, you risk causing malfunction and/or damage to speakers and other devices. 1. Make sure that all volume controls on the CUBE-30X and connected devices are set to 0. 2. Turn on all the devices connected to the CUBE-30X �s input jacks (INPUT jack and AUX IN jack). 3. Turn on the CUBE-30X. 4. Switch on any equipment connected to the CUBE-30X�s RECORDING OUT/PHONES jack. 5. Adjust the volume levels for the devices. 6. Before switching off the power, lower the volume on each of the devices in your system and then TURN OFF the devices in the reverse order to which they were switched on. * This unit is equipped with a protection circuit. A brief interval (a few seconds) after power up is required before the unit will operate normally. For protection from sudden big sound, always make sure to have the volume level turned down before switching on power. Even with the volume all the way down, you may still hear some sound when the power is switched on and off, but this is normal, and does not indicate a malfunction.
945 * If you need to turn off the power completely, first turn off the POWER switch, then unplug the power cord from the power outlet. Refer to �Power Supply� (p. 5).
921
* To prevent malfunction and/or damage to speakers or other devices, always turn down the volume, and turn off the power on all devices before making any connections. * Before making the connections, be sure that the volume setting of the VOLUME knob for both amplifiers is set to �0.�
926a
* When connection cables with resistors are used, the volume level of equipment connected to the inputs may be low. If this happens, use connection cables that do not contain resistors, such as those from the Roland PCS series.
9
|
|
|
> |
|
